Valve Mechanism Cover - Remove and Install
- Remove clamp (6) and hose (7) (if equipped).
- Remove nut (1), nut (4), clip (2), and clip (3). Position harness assembly (5) out of the way.
Show/hide table
Illustration 2 g03835459 - Remove studs (8), bolts (9), valve mechanism cover (10), and the gasket.
Show/hide table
Illustration 3 g03835507 - Remove clamp (12) and breather assembly (11).
Show/hide table
Illustration 1 | g03835389 |
- Install valve mechanism cover (10) in the reverse order of removal.
- Tighten clamp (12) to a torque of
8.5 ± 1 N·m (75 ± 9 lb in) .Show/hide tableIllustration 4 g03835520 - Tighten bolts (9) and studs (8) in numerical sequence shown in illustration 4 to a torque of
28 ± 7 N·m (249 ± 62 lb in) .
- Tighten clamp (12) to a torque of
Caterpillar Information System:
C9.3 Marine Engine Cylinder Block Cover - Remove and Install
3500 Engines Housing (Front)
C2.2 Engines For Caterpillar Built Machines Sensor Signal (Analog, Passive) - Test
3406E Engine Cylinder Head - Install
The Hose and Tube Assembly in the Service Brake Control Group May Fail on Certain 777G Off-Highway Trucks{4257, 4269} The Hose and Tube Assembly in the Service Brake Control Group May Fail on Certain 777G Off-Highway Trucks{4257, 4269}
C27 and C32 Engine for MD6250 and MD6310 Drill Coolant Level - Test
XQC1200 and XQC1600 Power Modules Circuit Breaker Panel - Remove and Install
442-1750 Lifting Plate{0374, 0599, 0629, 0632, 0700, 1122} 442-1750 Lifting Plate{0374, 0599, 0629, 0632, 0700, 1122}
C11, C13, C15, and C18 Industrial Engines NRS Exhaust Gas Temperature Is High
C9.3 Marine Engine Front Cover - Remove and Install
Procedure to Adjust Track Tension on Variable Gauge Undercarriages {4157, 4158} Procedure to Adjust Track Tension on Variable Gauge Undercarriages {4157, 4158}
3512C and 3516C Industrial Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
3600 Distillate Fuel Engines Maintenance Interval Schedule
PM820, PM822, and PM825 Cold Planer Lifting and Tying Down the Machine - Fixed Conveyor
C9.3 Marine Engine Cylinder Head - Remove and Install
3500B High Displacement Locomotive Engines Fuel Injector Mechanism
12M Motor Grader Wheel Lean Bearings - Lubricate
2015/07/07 An Improved Housing for the Throttle Inlet Is Used on Certain G3500 Engines {1071}
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Inspect
2015/08/14 A New Control Valve Assembly for Fuel Is Used on Certain 3500 Marine Engines {1261}
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Replace
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Right-Hand Service
C280-08 Tier 4 Engine Exhaust Manifold Shield - Remove and Install
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Combined Circuit Keel Cooling