Connectors for the Electronic Control Module (ECM)
Illustration 1 | g01890453 |
ADEM 4 ECM (J1/P1 ECM connector) 64-Pin connector (J2/P2 ECM connector) 64-Pin connector |
Harness Connector for the Fuel Actuator
Illustration 2 | g01941553 |
Harness Connector at the Throttle Actuator
Illustration 3 | g01941779 |
Power Converter
Illustration 4 | g01910374 |
Harness Connectors
Connector for the Interconnect Harness
Illustration 5 | g01941836 |
Connector for the Sensors at the Catalytic Converter
Illustration 6 | g02038838 |
Sensor Connectors
Analog Sensor Connector (Active)
Illustration 7 | g01240891 |
Analog Sensor Connector (Passive)
Illustration 8 | g01436505 |
Connectors for Oxygen Sensors
Illustration 9 | g01240891 |
Typical connector for the oxygen sensor and sensor buffer |
Connectors for the Termination Resistor
Illustration 10 | g01707176 |
Typical connector for the termination resistor |
Display Panel
Terminal Strip in the Display Panel
Illustration 11 | g02731375 |
Terminal locations from left to right for the terminal strip that is in the display panel (1) CAN shield (2) CAN data link− (3) CAN data link+ (4) Amber warning lamp (5) Red stop lamp (6) Engine running lamp (7) Speed potentiometer (8) Idle/rated speed switch (9) Engine stop signal (10) Engine running signal (11) Digital return (12) Unused (13) Crank terminate (14) Emergency stop (15) Keyswitch (16) −Battery (17) +Battery (18 and 19) Two resistors for the speed potentiometer |
Connector for the Messenger Display
Illustration 12 | g01941894 |
Aftertreatment Identification Module and Timing Selection Switch
Illustration 13 | g03685572 |
(20) Aftertreatment Identification Module (21) Timing Selection Switch Connector |
Illustration 14 | g03700464 |
Typical example of the customer supplied timing selection switch male connector (Terminal 1) Timing Selection Switch Signal (Terminal 2) Analog Return |