Engine Oil Lines
Show/hide table
Illustration 1 | g03412485 |
Show/hide table
Specification for 381-0522 Engine Oil Lines Gp | |||
Item | Qty | Part | Specification Description |
1 | 2 | 6B-9202 Spring | Length under test force is |
Test force is |
|||
Free length after test is |
|||
Cooling jet sequence valves must start to open at a pressure difference of |
|||
Cooling jet sequence valves must be fully open at |
|||
2 | 1 | 2W-1053 Plug | Torque to |
3 | 4 | 4F-8965 Bolt | Use the following procedure in order to tighten the bolts of the clamp assembly: 1. Tighten the clamp assembly until the clamp assembly snug to tube. 2. Tighten the clamp assembly to the elbow. 3. Tighten the clamp assembly to the tube. |
4 | 4 | 0S-1571 Bolt | |
5 | 2 | 237-7623 O-Ring Seal | Lubricate the bore lightly with the lubricant that is being sealed. |
6 | 1 | 124-4273 Bypass Valve | The oil cooler bypass valve to open with a pressure difference of |
7 | 1 | 2W-1635 Spring | Length under test force is |
Test force is |
|||
Free length after test is |
Caterpillar Information System:
C13 Generator Set Engine Fan - Remove and Install
C3.4B Industrial Engine Fuel Related Components in Cold Weather
3516C Marine Engines Water Lines
2013/07/30 New Service Replacement Stator Part Numbers for Certain XQ60, XQ100, and XQ175 Generator Sets are Now Available {4453}
2015/08/19 An Improved Seat Belt Group is Now Available for 311 through 390 Excavators {7327}
C27 and C32 Generator Sets Product Description
371-0351 Hydraulic Valve Seat Puller Group {0374, 0599, 0700, 0703} 371-0351 Hydraulic Valve Seat Puller Group {0374, 0599, 0700, 0703}
C7.1 Engines Fuel Pressure Sensor - Remove and Install
C13 Generator Set Engine Fan Drive - Assemble
C13 Generator Set Engine Fan Drive - Disassemble
C9.3 Industrial Engine Product Lifting
EMCPll+ Software Not Compatible With Certain G3400 Engines{4490} EMCPll+ Software Not Compatible With Certain G3400 Engines{4490}
UPS 750 Uninterruptible Power Supply DC Bus Capacitor - Replace
2013/08/30 New Software and Low Pressure Fuel System Are Used in Certain C175 Engines {1250, 1901, 1902}
2013/11/25 New Breather Assemblies Are Now Used on Certain C175 Engines {1317}
3516C Petroleum Engines Flywheel Housing
C175-20 Locomotive Engine Fuel System Operation
3512E Engines for Well Stimulation Pumps Auxiliary Drive Shaft
2013/08/09 New Software Is Used on Certain 3500 Petroleum Engines {1901, 1920}
3512C Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
2013/08/06 Improved Clamps are Now Used for the Cooling Lines Group on Certain Excavators {1351}
C13, C15, and C18 Generator Set Engines Piston and Rings
3512C Petroleum Engines Engine Speed/Timing Sensor - Remove and Install
2013/08/06 A New Upgraded Starter Is Used for Certain 3512, 3512B, 3512B HD, and 3512CEngines {1453}