Fuel Transfer Pump - Test
Show/hide table
 |
|
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. |
Show/hide table
| NOTICE |
|---|
|
Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately. |
Show/hide table
| NOTICE |
|---|
|
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component. |
Show/hide table
| |
| Illustration 1 | g03326638 |
|
Typical example | |
- Disconnect the inlet fuel hose (2) to the primary fuel filter (1).
- Place end of hose (2) into a suitable container.
- Turn the keyswitch to the START position. The fuel transfer pump (3) will begin to pump fuel. There will be the sound of the fuel transfer pump operating.
- Record the time taken to fill the container with
400 mL (13.6 oz) of fuel. The minimum limit is400 mL/min (13.6 oz/min) .
Caterpillar Information System:
3500 Industrial Engines Engine Speed/Timing Sensor
3512B and 3512C Petroleum Generator Set Engines Exhaust Fitting
3500C Marine Engines Cover Group (Front Housing)
3512B and 3512C Petroleum Generator Set Engines Exhaust Elbow
3500C Marine Engines Cover (Vibration Damper Guard)
3512B and 3512C Petroleum Generator Set Engines Exhaust Elbow
3512B and 3512C Petroleum Generator Set Engines Generator Coupling
3512B and 3512C Petroleum Generator Set Engines Exhaust Elbow
3500C Marine Engines Junction Box
C280 Marine and Petroleum Engines Data Link - Test
C18 Marine Auxiliary and Marine Generator Set Engines Cooling System - Test
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Engine Cranks but Does Not Start
C1.5 and C2.2 Engines for Caterpillar Built Machines Glow Plugs - Test
C1.5 and C2.2 Engines for Caterpillar Built Machines Exhaust Cooler (NRS) - Test - If Equipped
3500B High Displacement Thermocouple
3500 Engines for Caterpillar Built Generator Sets Engine Oil Lines
3512B and 3516B Generator Set Engines with Dynamic Gas Blending Engine Oil Lines
3500 Engines for Caterpillar Built Generator Sets Engine Oil Lines
3500C Marine Engines Engine Oil Lines
3516B Engine Engine Oil Pan (Front) - Remove and Install
3516B Engine Engine Oil Pan (Rear) - Remove and Install
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Sensor Calibration Required - Test
TA2 Technical Inspection for Certain 3512B and 3512C Petroleum Engines{1000} TA2 Technical Inspection for Certain 3512B and 3512C Petroleum Engines{1000}
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Switch Circuits - Test