Illustration 1 | g00308389 |
NOTICE |
---|
Improper lifting or tiedowns can allow load to shift and can cause injury and damage. |
The weights that are listed below and the instructions that are listed below describe the units that are repowered with an engine retrofit .
D11R Track-Type Tractor with Engine Retrofit | |
D11R without a Ripper, Counterweight, or Bulldozer | |
U Bulldozer | |
SU Bulldozer | |
Single Shank Ripper | |
Multi-Shank Ripper | |
Rear Counterweight | |
Additional Rear Counterweight | |
D11R CD Track-Type Tractor with Engine Retrofit | |
D11R CD without a Ripper, Counterweight, or Bulldozer | |
Bulldozer | |
Single Shank Ripper | |
Multi-Shank Ripper | |
Rear Counterweight | |
(1) | The rear counterweight is available on the D11R machine. |
Engage the parking brake before you sling the machine and before you secure the machine with tie-downs.
Illustration 2 | g00561816 |
A - Front tie-downs (two places) Use the front towing eye.
B - The ripper must be raised.
C - Lifting a machine without a ripper
D - Side tie-downs (two places) Use the inside edge of the track.
E - Rear tie-downs (two places) Use the drawbar, the outer edge of the track, or the ripper. The ripper must be lowered if this procedure is used.
The crane should be positioned so that the machine may be lifted in a level plane. The spreader bars should be wide enough to prevent contact between the crane and the machine that is being lifted.
Use properly rated cables and properly rated slings to lift the machine. For a machine without a ripper (C), position the slings beneath the front of the track and beneath the rear of the track. For a machine with a ripper (B), position the slings beneath the front of the track and under the ripper at the rear of the machine.
Use the front towing eye to secure the front tie-down (A). Use the inside edge of the track shoe (D) to secure the side tie-downs. Three places per side Use the drawbar, the ripper, or the outer edge of the track shoe (E) to secure the rear tie-downs. Use corner protectors on sharp corners.
Check all of the laws that govern the load characteristics (height, weight, width, and length).
Move the hydraulic activation control lever to the Locked position.
Consult your Cat dealer for shipping instructions for your machine.