Fuel Injection Pump Housing
Show/hide table
Illustration 1 | g00368853 |
Show/hide table
Illustration 2 | g00705953 |
Area A Area B |
(1) The bearing is installed from the edge of the housing by the following value. ... 4.8 ± 0.5 mm (0.19 ± 0.02 inch)
(3) The bearing is installed from the edge of the housing by the following value. ... 1.0 ± 0.5 mm (0.039 ± 0.020 inch)
For bearings (1), (2), and (3), the bearings' joint clearance must be within 30 ± 1 degrees of the top center. Refer to (6) Illustration 2 for further information. The bearing oil hole must be within 30 ± 1 degrees. Refer to (7) Illustration 2 for further information.
(5) The distance from the bottom of the housing to the end of the dowel ... 1.5 ± 0.3 mm (0.059 ± 0.012 inch)
Caterpillar Information System:
C15 Generator Set Engines CAN Data Link Circuit - Test
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Adjuster - Assemble
Start-up Procedure after a System Generated Shutdown{1000} Start-up Procedure after a System Generated Shutdown{1000}
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Upper Frame and Undercarriage Frame - Connect
Hydraulic Cylinder Seal Failure Analysis {7555, 7562} Hydraulic Cylinder Seal Failure Analysis {7555, 7562}
C1.5 and C2.2 Generator Set Engines Pistons and Connecting Rods - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Adjuster - Disassemble
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Selector Valve (Alternate Pattern Control) - Install
C1.5 and C2.2 Generator Set Engines Camshaft - Install
Modifying the Air Shutoff Valve{1078, 1078} Modifying the Air Shutoff Valve{1078, 1078}
C175-16 and C175-20 Engines for Caterpillar Built Machines Valve Cover - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Bucket - Remove
C1.5 and C2.2 Generator Set Engines Pistons and Connecting Rods - Install
C15 Generator Set Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
3412 Generator Set Engines Fuel Injection Pump
Using Lock-N-Stitch Procedures for Casting Repair {0676, 0685} Using Lock-N-Stitch Procedures for Casting Repair {0676, 0685}
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swivel - Disassemble
3412 Generator Set Engines Fuel Transfer Pump
3412 Generator Set Engines Fuel Transfer Pump
C15 Generator Set Engines Ether Injection System - Test
C15 Generator Set Engines E255 Diagnostic Reset
C1.5 and C2.2 Generator Set Engines Connecting Rod Bearings - Remove
C1.5 and C2.2 Generator Set Engines Connecting Rod Bearings - Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swivel - Assemble