Aftercooler
Show/hide table
Illustration 1 | g01230778 |
Tighten bolts (1 through 16) in a numerical sequence.
Tighten the bolts to the following torque. ... 31 ± 3 N·m (23 ± 2 lb ft)
Caterpillar Information System:
Product Link PL-102C{7602} Product Link PL-102C{7602}
C7 Marine Engine Crankcase Breather
3500B Locomotive Engines Engine Mounts - Check
3406E and 3456 Generator Set Engines Engine Will Not Crank
C7 Marine Engine Turbocharger - Inspect
3406E and 3456 Generator Set Engines System Configuration Parameters
C-10 Petroleum Engine Engine Oil Level - Check
C11 and C13 Engines Cylinder Head Valves
SCJ and 8SC Series Alternators Brush Length - Check
SCJ and 8SC Series Alternators Brush Assembly - Test
SCJ and 8SC Series Alternators Residual Magnetism - Restore
3406E, C-10 and C-12 On-highway Engines 0254-12 ECM Fault (53)
Requirements for Installation of the 197-6700 Piston {1214, 1216} Requirements for Installation of the 197-6700 Piston {1214, 1216}
3114, 3116, 3126 Engines Rear Seal Carrier
C-10 Petroleum Engine Fuel System Secondary Filter - Replace
3408E and 3412E Engines for Caterpillar Built Machines Atmospheric Pressure Sensor
3512B and 3516B High Displacement Locomotive Engines After Stopping Engine
2004/04/01 Revised Special Instruction, REHS2115, "Requirements for Installation of the 197-6700 Piston " is Available {1214, 1216}
3512B and 3516B High Displacement Locomotive Engines Refill Capacities and Recommendations
C27 and C32 Industrial Engines Monitoring System - If Equipped
C11 and C13 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C7 Marine Engine Cooling System - Inspect
C7 Engines for Caterpillar Built Machines Water Temperature Regulator - Test
C7 Marine Engine Electric Starting System - Test