Prelube Pump - Electric
Show/hide table
图 1 | g00996133 |
预润滑泵操作期间的发动机机油流(典型图例) (1) 机油压力开关盒 (2) 继电器盒 (3) 预润滑泵马达 (4) 预润滑泵 |
预润滑泵是一个选装件,它可在发动机起动之前向发动机提供润滑。 由于因移动部件干接触而造成的磨损机率降低,发动机的使用寿命得以延长。
图1和图2是典型示例。 根据用户需要,由几种预润滑方式可供选择。 电源供电、接线和电气控制装置由用户提供。
用户向盒 (1) 内的常闭机油压力开关提供接线和电源。 用户提供的接线将该开关与盒 (2) 内的一个继电器线圈连接起来。 通向继电器线圈的电源使继电器触点闭合。 预润滑泵马达 (3) 的电源经由继电器触点供电。 马达运转预润滑泵 (4) 。
预润滑泵从发动机油底壳吸入发动机机油。 这些机油被向上泵送到机油冷却器的进口弯管内。 这些机油在发动机内正常循环流动。
一个软管从缸体主油道连接到盒 (1) 中的机油压力开关。 当发动机机油压力上升到机油压力开关的压力额定值时,开关打开。 这将中断继电器2线圈的电源供电,继电器触点打开。 这将中断预润滑泵马达的供电。 预润滑泵停止转动。
Show/hide table
图 2 | g01024481 |
电动预润滑泵的典型示意图 |
图2是以上所描述的电动预润滑泵的典型示意图。 注意该继电器有一对未使用的触点。 用户可使用这些触点来激发指示灯或指示器。 该电路图只作参考之用。 用户决定继电器的功能和接线的布线。
Caterpillar Information System:
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
3500B and 3500C Marine Propulsion Engines Synchronizing Switch Not Functioning Properly
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3500B and 3500C Marine Propulsion Engines Throttle Position Sensor
G3304 and G3306 Engines Magneto - Remove and Install
G3304 and G3306 Engines Accessory Drive - Assemble
G3304 and G3306 Engines Accessory Drive - Disassemble
3618 Engine Turbocharger - Inspect
G3304 and G3306 Engines Service Meter - Remove and Install
3054E Industrial Engine Fuel Injection Nozzles - Install
3054E Industrial Engine Fuel Injection Nozzles - Remove
G3304 and G3306 Engines Magneto - Disassemble
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Remove
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Relief Valve - Remove and Install
G3520B Industrial Engine Throttle Actuator
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Install
C1.5 and C2.2 Generator Rotor - Remove and Install
3054C Industrial Engine Fuel Injection Pump - Remove - Bosch EVPE
3054C Industrial Engine Fuel Injection Pump - Install - Bosch EVPE
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator Housing - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Filter Base
C1.5 and C2.2 Marine Generator Set Engines Expansion Tank - Remove and Install
G3520C and G3520E Generator Set Engines Cylinder Head - Disassemble