Service Meter - Remove and Install
- Remove bolts (1), clamps (2), and service meter (3) from the drive group.
Show/hide table
Illustration 1 | g01004496 |
The magneto is removed for photo purposes only. |
- Inspect seal (4) for damage. Replace seal (4), if necessary.
- Apply clean engine oil on seal (4) and install seal (4) on service meter (3).
- Place service meter (3) into position on the drive group. Ensure that service meter (3) is in the correct position with the groove in the drive shaft.
- Install clamps (2) and bolts (1). Tighten bolts (1) to a torque of
10.8 ± 2.7 N·m (96 ± 24 lb in) .
Show/hide table
Illustration 2 | g00995733 |
Caterpillar Information System:
3054E Industrial Engine Fuel Injection Nozzles - Install
3054E Industrial Engine Fuel Injection Nozzles - Remove
G3520B Industrial Engine Electrical Power Supply
Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202} Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202}
C1.5 and C2.2 Generator Generator Operation
3618 Engine Aftercooler Core - Clean/Test
3054E Industrial Engine Fuel Injection Lines - Remove and Install
G3304 and G3306 Engines Accessory Drive - Remove and Install
G3520C and G3520E Generator Set Engines Water Pump - Install
G3520C and G3520E Generator Set Engines Water Pump - Remove
3500B and 3500C Marine Propulsion Engines System Overview
C4.4 (Mech) Industrial Engine Glow Plugs - Test
3618 Engine Turbocharger - Inspect
G3304 and G3306 Engines Accessory Drive - Disassemble
G3304 and G3306 Engines Accessory Drive - Assemble
G3304 and G3306 Engines Magneto - Remove and Install
3500B and 3500C Marine Propulsion Engines Throttle Position Sensor
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3500B and 3500C Marine Propulsion Engines Synchronizing Switch Not Functioning Properly
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
G3500 Engines Prelube Pump - Electric
G3304 and G3306 Engines Magneto - Disassemble
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Remove