Fuel Injection Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Position the correct number of shims (3) on the mounting face of the cylinder block. Refer to Specifications, "Fuel Injection Pump".
Show/hide table
Illustration 1 | g00825137 |
Show/hide table
Illustration 2 | g00825132 |
- Position fuel injection pump (1) close to the mounting face of the cylinder block, and connect link (6) and fuel rack control (5) with clip (7) .
- Position fuel injection pump (1) on the mounting face of the cylinder block.
- Install bolts (4) and nuts (2) that fasten the fuel injection pump to the cylinder block.
Tighten bolts (4) and nuts (2) to a torque of 15 N·m (11 lb ft).
End By:
- Install the engine speed actuator. Refer to Disassembly and Assembly, "Engine Speed Actuator - Remove and Install".
- Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
Caterpillar Information System:
C1.5 and C2.2 Generator Set Engines Fuel Injection Lines - Remove and Install
3456 Generator Sets Generator Installation
3500B Engines for Caterpillar Built Power Modules Thermostatic Valve
3500B and 3500C Marine Propulsion Engines Engine Monitoring System
3456 Generator Sets Generator Identification
G3520C and G3520E Generator Set Engines Throttle Control Valve - Install
G3520C and G3520E Generator Set Engines Throttle Control Valve - Remove
3456 Generator Sets Generator Description
G3520C and G3520E Generator Set Engines Actuator Bypass Valve (Variable) - Remove
3054E Industrial Engine Fuel Injection Pump - Remove
C3.3 and C4.4 Generator Sets Fuel System Primary Filter (Water Separator) Element - Replace
C4.4 Industrial Engine Engine Oil Level - Check
3406C Generator Sets Sensors and Electrical Components
C1.5 and C2.2 Marine Generator Set Engines Flywheel Housing - Remove and Install
3500B and 3500C Marine Propulsion Engines System Configuration Parameters
Installation of Fuel/Water Separator{1260, 1263} Installation of Fuel/Water Separator{1260, 1263}
C1.5 and C2.2 Marine Generator Set Engines Crankshaft Pulley - Remove and Install
C1.5 and C2.2 Marine Generator Set Engines Valve Mechanism Cover - Remove and Install
C1.5 and C2.2 Marine Generator Set Engines Rocker Shaft and Pushrod - Install
3456 Generator Sets Engine Shutoffs and Engine Alarms
3456 Generator Sets Overspeed
3412C Generator Sets Starting the Engine - EMCP II and EMCP II+ (If Equipped)
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Remove
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Install