Ignition Wiring Harness - Remove and Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件说明 | 数量 |
A | 151-6320 | 拆卸工具 | 1 |
- 切断供电。
- 断开主点火线束 (1)。
- 将线束 (3) 从壳体 (2) 上断开。
Show/hide table
图 2 g00876154 - 卸下固定主点火线 (4) 的扎带 (5)。
- 使用工具 (A) 将主点火线从电子控制模块(ECM)的接头上卸下。
- 从 ECM 接线盒(未显示)底部断开点火配线线束。
- 从接线盒中拉出主点火线。
Show/hide table
图 3 g00876157 - 卸下安装螺栓 (6)。
- 小心地从支架 (7) 上提起壳体。
Show/hide table
图 1 | g00876151 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 小心地将壳体放在支架 (7) 上。
- 安装安装螺栓 (6)。
Show/hide table
图 5 g00876154 - 将主点火线 (4) 穿过接线盒。
- 将点火配线线束连接至 ECM 接线盒(未显示)底部。
- 将主点火线插入 ECM 上的接头。
- 安装扎带 (5)。
Show/hide table
图 6 g00876151 - 连接线束 (3) 至壳体 (2)。
- 连接主点火线束 (1)。
- 重新供电。
Show/hide table
图 4 | g00876157 |
Caterpillar Information System:
2002/04/01 Change to Disassembly and Assembly Manual {1157}
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
2002/03/01 Change to Disassembly and Assembly Manual {1157}
G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install
3056E Industrial Engine Exhaust Manifold
G3612 and G3616 Engines Electronic Control Module - Remove and Install
2002/03/01 New Specification For The Minimum Fuel Pressure At The Inlet To The Fuel Transfer Pump {1274}
G3612 and G3616 Engines Integrated Combustion Sensing Module (ICSM) - Remove and Install
Setup of the Machine Security System{7631} Setup of the Machine Security System{7631}
3176C and 3196 Engines for Caterpillar Built Machines Connecting Rod
G3612 and G3616 Engines Water Pump Pressure Switch - Remove and Install
3126E On-highway Engine Engine Oil Pump - Disassemble
3126E On-highway Engine Engine Oil Pump - Assemble
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
2002/03/01 Change to Specifications Manual {1157}
G3408C and G3412C Engines Carburetor Control Linkage
C-12 Marine Engines Fuel Filter Base - Remove
C-12 Marine Engines Fuel Filter Base - Install
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
3500 Generator Set Engines Pressure Switch