Change to Disassembly and Assembly Manual {1157}
- Industrial Engines:
- C-10 (S/N: BCX)
- Marine Engines:
- 3176C (S/N: 6BW)
- C-12 (S/N: BDL; CPN; JAC)
- 3176C (S/N: 5DZ; CRJ)
- 3196 (S/N: 2XR)
Reference: A torque sequence for the bolts that mount the flywheel housing to the cylinder block has been added to the Installation Procedure for the flywheel housings on these engines. This change is shown in the text that follows. This change will be included in the next revision of these manuals.
Installation Procedure
- Apply 1U-6396 O-Ring Assembly Compound to O-ring seal (4). Install O-ring (4) .
Show/hide table
Illustration 1 | g00514040 |
- Apply 1U-8846 Sealant (6) to the face of the cylinder block. Refer to Illustration 1.
- Make sure that dowels (3) are installed in the rear of the cylinder block. Position the flywheel housing on dowels (2) on the rear of the cylinder block. Install twelve bolts (1) and the washers. Use the torque sequence that is shown in Illustration 3 to tighten bolts (1) .
Show/hide table
Illustration 2 | g00514036 |
Show/hide table
Illustration 3 | g00871860 |
Torque sequence |
End By:
a. - Install the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Install".
b. - Install the flywheel. Refer to Disassembly and Assembly, " Flywheel - Install".
Caterpillar Information System:
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
2002/03/01 Change to Disassembly and Assembly Manual {1157}
G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install
3056E Industrial Engine Exhaust Manifold
G3612 and G3616 Engines Electronic Control Module - Remove and Install
2002/03/01 New Specification For The Minimum Fuel Pressure At The Inlet To The Fuel Transfer Pump {1274}
G3612 and G3616 Engines Integrated Combustion Sensing Module (ICSM) - Remove and Install
Setup of the Machine Security System{7631} Setup of the Machine Security System{7631}
3176C and 3196 Engines for Caterpillar Built Machines Connecting Rod
G3612 and G3616 Engines Water Pump Pressure Switch - Remove and Install
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies User Interface for Multiple Module Unit
G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install
3126E On-highway Engine Engine Oil Pump - Disassemble
3126E On-highway Engine Engine Oil Pump - Assemble
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
2002/03/01 Change to Specifications Manual {1157}
G3408C and G3412C Engines Carburetor Control Linkage
C-12 Marine Engines Fuel Filter Base - Remove
C-12 Marine Engines Fuel Filter Base - Install
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure