Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | FT-2674(1) | Vacuum Cap | 1 |
(1) | Extension |
Start By:
- Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Open storage box (1) for the window guards.
Show/hide table
Illustration 2 g01571093 - Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply
276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.Show/hide tableIllustration 3 g01583873 - Remove bolts (2) and remove cover (3).
Show/hide table
Illustration 4 g01584534 - Disconnect seven hose assemblies (4).
Show/hide table
Illustration 5 g01584579 - Remove rubber covers (5) from the pedals.
Show/hide table
Illustration 6 g01584634 - Remove bolts (6) and remove pedals (7).
Show/hide table
Illustration 7 g01584674 - Remove bolts (8) and remove travel valve (9).
Illustration 1 | g01571895 |