Purge System
An air purge system has been utilized in the CPS361 Cement Pumper. The system provides a air purge to the following components that is classified as "Type Z":control panel, digital gauge, interconnect barrier/junction box and battery disconnect enclosure This is a continuous air purge. The air purge system should be activated for a minimum of 7 minutes prior to energizing the power to the control system. An indicator that is located on the front of the enclosure provides a quick reference for the operator. A green light indicates that the system is working correctly. A red light warns the operator that the air purge system has failed. Verify that all enclosure doors are properly secured and verify that the air supply is still pressurized. The enclosure for the air purge system is located to the right hand side of the control console. Proper operation of the CPS361 Cement Pumper depends on the supply of clean, dry air.
Note: For units with the Class I Division II Groups C, D Hazardous Location CSA Certification, the supply of clean, dry air is a requirement.
Caterpillar Information System:
G3606 and G3608 Engines Crankshaft Rear Seal - Install
G3606 and G3608 Engines Crankshaft Rear Seal - Remove
G3408 and G3412 Engines Auxiliary Water Pump
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Assemble
3406C (PEEC III) Truck Engines Compression Brake
Control Console For CPS361 Pumper, Cement Engine Electronics
G3606 and G3608 Engines Crankshaft Front Seal and Wear Sleeve - Install
G3606 and G3608 Engines Crankshaft Front Seal and Wear Sleeve - Remove
Control Console For CPS361 Pumper, Cement Battery Disconnect
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Control Panel (AC Power)
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Heat Exchanger
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers High Speed Coupling for Gearbox
G3408 and G3412 Engines Air Cleaner
G3408 and G3412 Engines Auxiliary Drive
G3408 and G3412 Engines Stub Shaft (Rear)
G3408 and G3412 Engines Rear Power Take-Off (RPTO)
G3304 and G3306 Engines Gas Shutoff Valve
G3408 and G3412 Engines Gas Solenoid Valve
G3408 and G3412 Engines Coolant Temperature Sender
G3500B Engines Engine Operation
G3408 and G3412 Engines Coolant Temperature Contactor
3608 Engine Crankshaft Rear Gear - Remove and Install
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Pump (Gearbox Oil)
G3408 and G3412 Engines Engine Oil Pressure Sender