Engine Oil Filter Base - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install engine oil filter base (4) on the engine block.
Show/hide table
Illustration 1 | g00554000 |
Typical example |
- Place the hose clamp in position and install nut (3) .
- Install three bolts (2) .
- Connect two hoses and tighten two hose clamps (1) .
Caterpillar Information System:
Generator Set Control Panel for Switchgear Conversion LH/RH Switch - Troubleshoot
3054 Engine for Caterpillar Built Machines Engine Oil Filter Base - Remove
Generator Set Control Panel for Switchgear Conversion Initial Troubleshooting Procedure
3054 Engine for Caterpillar Built Machines Cylinder Liner - Install
3054 Engine for Caterpillar Built Machines Cylinder Liner - Remove
Generator Set Control Panel for Switchgear Conversion Troubleshooting Diagnostic Codes
SR4 HV and SR4B HV Generators Insulation - Test
3054 and 3056 Industrial and Generator Set Engines Water Outlet Manifold - Install
3054 and 3056 Industrial and Generator Set Engines Water Outlet Manifold - Remove
Generator Set Control Panel for Switchgear Conversion Accessing Diagnostic Information
3408E and 3412E Engines for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
797 Off-Highway Truck Hydraulic System Relief Valve (Hoist)
3054 Engine for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
Control Console For CPS361 Pumper, Cement General Information
3054 Engine for Caterpillar Built Machines Engine Oil Filter Base - Assemble
Generator Set Control Panel for Switchgear Conversion Scroll Switch - Troubleshoot
Jacket Water Heaters, Lube Oil Heaters, and Combination Heaters for G3600, 3600, and C280 Engines Electrical System Schematic
Generator Set Control Panel for Switchgear Conversion System Self Test
Generator Set Control Panel for Switchgear Conversion Module - Replace
3608 Engine Engine Oil Pan - Assemble
Generator Set Control Panel for Switchgear Conversion Main Display Module Initialization - Adjust
Generator Set Control Panel for Switchgear Conversion Indicator for Overcrank - Troubleshoot
3054 and 3056 Industrial and Generator Set Engines Camshaft
G3606 and G3608 Engines Oil Temperature Regulators - Remove and Install