Flexible Coupling (5L3395)
Usage:
Maximum out of square dimension between face of outer coupling and shaft ... .008 in.(0,20 mm)
(1) Maximum out of round dimension between outside diameter of outer coupling and shaft ... .008 in.(0,20 mm)
(2) Clearance between rear plate and center coupling ... .009 in.(0,23 mm)
(3) Clearance between front plate and center coupling ... .009 in.(0,23 mm)
Caterpillar Information System:
6.25" BORE ENGINE ATTACHMENTS Enclosed Clutches
6.25" BORE ENGINE ATTACHMENTS Hydraulic Starting System
6.25" BORE ENGINE ATTACHMENTS Air Starting Motors (3H3170, 3H3171)
6.25" BORE ENGINE ATTACHMENTS Prelubrication Pump And Air Motor
6.25" BORE ENGINE ATTACHMENTS Air Valves For Air Starting System
6.25" BORE ENGINE ATTACHMENTS Contactor Switches (Oil Pressure)
6.25" BORE ENGINE ATTACHMENTS Shut-Off Solenoids
6.25" BORE ENGINE ATTACHMENTS Shut-Off Valve (Air Inlet) (2N9924, 7L5536)
6.25" BORE ENGINE ATTACHMENTS Shut-Off Valve (Water Temperature) (4L7108)
6.25" BORE ENGINE ATTACHMENTS Overspeed Contactor Switch
6.25" BORE ENGINE ATTACHMENTS Contactor Switches (Water Temperature)
6.25" BORE ENGINE ATTACHMENTS Pressure Switches
SCSA SOLID STATE MAGNETO Glossary
SCSA SOLID STATE MAGNETO Introduction
SCSA SOLID STATE MAGNETO Typical Ignition Cycle Per Cylinder
SCSA SOLID STATE MAGNETO Failure Analysis
SCSA SOLID STATE MAGNETO Generator Coil Installation
SCSA SOLID STATE MAGNETO Mechanical Drive Disassembly
SCSA SOLID STATE MAGNETO Distribution Board Installation (12 Cylinder Magneto)
SCSA SOLID STATE MAGNETO Distribution Board Installation (6 and 8 Cylinder Magnetos)
SCSA SOLID STATE MAGNETO Power Resistor Installation
SCSA SOLID STATE MAGNETO Power Board Installation
SCSA SOLID STATE MAGNETO Zener Diode Installation
SCSA SOLID STATE MAGNETO Storage Capacitor Installation