Flywheel
Usage:
Typical Illustration
(1) Flywheel shoulder.
(2) Install ring gear so that part No. is on this side. Ring gear must be assembled against shoulder of flywheel.
NOTE: Do not heat ring gear to more than 204°C (400°F) before installing on flywheel.
(3) Pilot bore.
(4) Torque for bolts holding flywheel to crankshaft ... 90 ± 7 N·m (66 ± 5 lb ft)
Put 5P3413 Pipe Sealant on the bolt threads.
NOTE: Dash mark on flywheel must be in alignment with dash mark on crankshaft.
Caterpillar Information System:
3208 INDUSTRIAL & MARINE ENGINES Pulley And Damper
3208 INDUSTRIAL & MARINE ENGINES Flywheel Housing Bore
3208 INDUSTRIAL & MARINE ENGINES Flywheel Housing Runout Face Runout (Axial Eccentricity) Of The Flywheel Housing:
3208 INDUSTRIAL & MARINE ENGINES Flywheel Runout
3208 INDUSTRIAL & MARINE ENGINES Bearings For Connecting Rods And Mains
3208 INDUSTRIAL & MARINE ENGINES Crankshaft
3208 INDUSTRIAL & MARINE ENGINES Crankshaft Seals
3208 INDUSTRIAL & MARINE ENGINES Pistons And Rings
3208 INDUSTRIAL & MARINE ENGINES Connecting Rod
3208 INDUSTRIAL & MARINE ENGINES Cylinder Block
3208 INDUSTRIAL & MARINE ENGINES Belt Tension Chart
3208 INDUSTRIAL & MARINE ENGINES Water Temperature Regulator
3208 INDUSTRIAL & MARINE ENGINES Alternators And Regulators
3208 INDUSTRIAL & MARINE ENGINES Regulator
3208 INDUSTRIAL & MARINE ENGINES Electric Starter Motor
3208 INDUSTRIAL & MARINE ENGINES Shutoff Solenoids
3208 INDUSTRIAL & MARINE ENGINES Systems Operation
3208 INDUSTRIAL & MARINE ENGINES Testing & Adjusting
ELECTRICAL PROTECTION SYSTEM ENERGIZE TO RUN (SI-ETR) Systems Operation
ETR ELECTRICAL PROTECTION SYSTEM Electric Protection System Functional Tests
ETR ELECTRICAL PROTECTION SYSTEM Troubleshooting Full Protection System - Energize To Run System - Oil Pressure, Water Temperature, Overspeed Protection
ETR ELECTRICAL PROTECTION SYSTEM Service Procedures
CONTROL PANEL (STATUS-TIMING) FOR 3500 SPARK IGNITED ENGINES Systems Operation
CONTROL PANEL (STATUS-TIMING) FOR 3500 SPARK IGNITED ENGINES Testing and Adjusting