Turbocharger - Assemble
组装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
注意 |
---|
压缩机壳体必须在涡轮增压器组件上保持平直不倾斜。 倾斜可能会导致压缩机叶片倾翻或导致压缩机轴损坏。 |
- 将压缩机壳体 (1) 和涡轮壳体 (4) 安置在涡轮增压器管壳 (5) 上。
Show/hide table
图 1 | g01237470 |
- 拧紧 V 形带箍 (2) 上的螺母至扭矩为 14 ± 1 N·m (10 ± 1 lb in)。 用软面锤轻轻敲击卡箍直径周围区域。 拧紧螺母至扭矩为 14 ± 1 N·m (10 ± 1 lb ft)。
注: 确保配合面平整。
- 拧紧 V 形带卡箍 (6) 上的螺母至扭矩为 14 ± 1 N·m (10 ± 1 lb in)。 用软面锤轻轻敲击卡箍直径周围区域。 再次拧紧螺母至扭矩为 14 ± 1 N·m (10 ± 1 lb ft)。
- 确保叶轮可以自由旋转。
- 将软管 (3) 连接到压缩机壳体上。
End By: 安装涡轮增压器。 请参阅 拆解和组装, "涡轮增压器 - 安装"。
Caterpillar Information System:
420E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Sound Information and Vibration Information
2006/03/27 A New Differential Ring Gear Is Now Used {3256, 3258, 3281}
24M Motor Grader Machine Systems Drawbar
C15 and C18 Generator Set Engines Turbocharger - Disassemble
587T Pipelayer Power Train Main Relief Valve
24M Motor Grader Machine Systems Articulation Cylinder Mounting
2006/02/06 An Improved Lip Type Seal Is Available for the Pump Drive {3108, 7555}
2006/02/06 Correction to Disassembly and Assembly , "Differential and Bevel Gear (Center) - Assemble" {3256, 3258}
2006/02/06 Correction to Disassembly and Assembly , "Differential and Bevel Gear (Front and Rear) - Assemble" {3256, 3258}
2006/01/30 Correction to Disassembly and Assembly , "Differential and Bevel Gear (Center) - Assemble" {3256, 3258}
2006/01/30 Correction to Disassembly and Assembly , "Differential and Bevel Gear (Front and Rear) - Assemble" {3256, 3258}
2006/02/06 Correction to Disassembly and Assembly , "Differential and Bevel Gear (Front and Rear) - Assemble" {3256, 3258}
C15 and C18 Generator Set Engines Exhaust Manifold - Remove and Install
REFERENCE CHART FOR QUICK DISCONNECTS ON WORK TOOLS{4283, 5057, 6700, 7000} REFERENCE CHART FOR QUICK DISCONNECTS ON WORK TOOLS{4283, 5057, 6700, 7000}
587T Pipelayer Power Train Transmission
24M Motor Grader Machine Systems Blade Mounting
24M Motor Grader Machine Systems Muffler
Field Service for Positive Pin Retention Track {4169, 4170, 4175} Field Service for Positive Pin Retention Track {4169, 4170, 4175}
2006/02/13 Enhanced Voltmeter Leads Are Now Available {0785}
24M Motor Grader Machine Systems Ripper
C15 and C18 Generator Set Engines Engine Oil Filter Base - Remove
587R Pipelayer Power Train Transmission
140H and 160H Motor Graders Sound Information and Vibration Information
C15 and C18 Generator Set Engines Engine Oil Filter Base - Install