3208 TRUCK ENGINE Caterpillar


EGR Actuator And EGR Valve

Usage:

Calibration of Linkage

(1) Push up on lever and install 5P7345 Calibration Gauge in small opening of EGR valve.

(2) Loosen locknut. Turn rod out of rod end a few turns. Turn rod into rod end until resistance is felt.

(3) Tighten locknut to ... 63 ± 13 lb.in.(7.0 ± 1.5 N·m)

Wire on solenoids must be toward cylinder block.

Oil lines must be installed so they do not make contact with other lines.

Seals in oil lines to solenoids must be lubricated lightly with lubricant being sealed.

Seals in oil line from EGR actuator to the sump must be lubricated lightly with lubricant being sealed.

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.