Flywheel Housing Runout
Usage:
Face Runout (axial eccentricity) of the Flywheel Housing:
8T5096 DIAL INDICATOR GROUP INSTALLED
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
3. With dial indicator set at .000 in. (0.0 mm) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).
4. The difference between lower and higher measurements taken at all four points must not be more than .010 in. (0.25 mm), which is the maximum permissible face run out (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
3208 TRUCK ENGINE Flywheel Runout
3208 TRUCK ENGINE Mounting Group For AT540, MT643, And MT653 Allison Transmission
3208 TRUCK ENGINE Flywheel
3208 TRUCK ENGINE Fan Mounting Pulley Assemblies
3208 TRUCK ENGINE Pulley And Damper
3208 TRUCK ENGINE Crankshaft
3208 TRUCK ENGINE Bearings For Connecting Rods And Mains
3208 TRUCK ENGINE Pistons And Rings
3208 TRUCK ENGINE Connecting Rod
3208 TRUCK ENGINE Cylinder Block
3208 TRUCK ENGINE V-Belt Tension Chart
3208 TRUCK ENGINE Water Temperature Regulator (9N5121)
3208 TRUCK ENGINE Flywheel Housing Bore
3208 TRUCK ENGINE Alternators
3208 TRUCK ENGINE Electric Starter Motors
3208 TRUCK ENGINE Starter Solenoids
3208 TRUCK ENGINE Shutoff Solenoid
3208 TRUCK ENGINE Air Compressor
3208 TRUCK ENGINE System Operation
3208 TRUCK ENGINE Testing And Adjusting
3208 TRUCK ENGINE Introduction To The Troubleshooting Guide
3208 TRUCK ENGINE Primary Engine Test For Low Power
3208 TRUCK ENGINE Low Power Troubleshooting - (Diagnosing with Chassis Dynamometer)
3208 TRUCK ENGINE Primary Engine Test For High Fuel Consumption