Remove Actuator And EGR Valve
Usage:
Remove Actuator And EGR Valve
1. Remove four bolts (2). Then remove cover (1) for the actuator and EGR valve.
2. Disconnect lines (3) and (6). Remove nuts and bolts (4) that hold actuator and EGR valve to the exhaust manifold and EGR tube.
3. Remove actuator and EGR valve (5). Remove and inspect gaskets on exhaust manifold and EGR tube. Make a replacement if necessary.
Install Actuator And EGR Valve
1. Install new gaskets on exhaust manifold and EGR tube.
2. Put actuator and EGR valve (1) in position on the exhaust manifold and EGR tube. Install the nuts and bolts that hold the unit.
3. Connect the three lines (2) and (3) to the oil cooler and oil pan.
4. Install cover (4) with the bolts that hold it.
Caterpillar Information System:
3208 TRUCK ENGINE EGR Switch Assembly
3208 TRUCK ENGINE Fuel Setting
3208 TRUCK ENGINE Automatic Timing Advance Unit 3° For EGR Engine
3208 TRUCK ENGINE EGR Actuator And EGR Valve
3208 TRUCK ENGINE EGR Valve
3208 TRUCK ENGINE EGR Actuator
3208 TRUCK ENGINE EGR Tube
3208 TRUCK ENGINE Breather
3208 TRUCK ENGINE Air Inlet Manifold
3208 TRUCK ENGINE Testing And Adjusting
3208 TRUCK ENGINE Systems Operation
3208 TRUCK ENGINE Reconditioning Procedures
3208 TRUCK ENGINE Actuator
3208 TRUCK ENGINE Air Inlet Manifold
3208 TRUCK ENGINE Crankcase Breather
D353 INDUSTRIAL & MARINE ENGINES Introduction
D353 INDUSTRIAL & MARINE ENGINES Fuel Injection Equipment
D353 INDUSTRIAL & MARINE ENGINES Fuel Transfer Pump
D353 INDUSTRIAL & MARINE ENGINES Fuel Pump And Governor Drive
D353 INDUSTRIAL & MARINE ENGINES Fuel Filter
D353 INDUSTRIAL & MARINE ENGINES Camshaft And Timing Gears
D353 INDUSTRIAL & MARINE ENGINES Accessory Drive Group
D353 INDUSTRIAL & MARINE ENGINES Gear Group (Camshaft Idler and Power Take-Off Idler)
D353 INDUSTRIAL & MARINE ENGINES Governor (Earlier)