EGR Actuator And EGR Valve
Usage:
Calibration of linkage
(1) Push up on lever and install 5P7345 Calibration Gauge in small opening of EGR valve.
(2) Loosen locknut. Turn rod out of rod end a few turns. Turn rod into rod end until resistance is felt.
(3) Tighten locknut to ... 31.2 ± 4.5 lb.in.(3.5 ± 0.5 N·m).
Wire on solenoids must be toward cylinder block.
Oil lines must be installed so they do not make contact with other lines.
Seals in oil lines to solenoids must be lubricated lightly with lubricant being sealed.
Seals in oil line from EGR actuator to the sump must be lubricated lightly with lubricant being sealed.
Caterpillar Information System:
3208 TRUCK ENGINE EGR Valve
3208 TRUCK ENGINE EGR Actuator
3208 TRUCK ENGINE EGR Tube
3208 TRUCK ENGINE Breather
3208 TRUCK ENGINE Air Inlet Manifold
3208 TRUCK ENGINE Testing And Adjusting
3208 TRUCK ENGINE Systems Operation
3208 TRUCK ENGINE Reconditioning Procedures
3208 TRUCK ENGINE Camshaft Bearings
3208 TRUCK ENGINE Crankshaft And Gear
3208 TRUCK ENGINE Flywheel Housing
3208 TRUCK ENGINE Crankshaft Rear Seal Wear Sleeve
3208 TRUCK ENGINE Automatic Timing Advance Unit 3° For EGR Engine
3208 TRUCK ENGINE Fuel Setting
3208 TRUCK ENGINE EGR Switch Assembly
3208 TRUCK ENGINE Remove Actuator And EGR Valve
3208 TRUCK ENGINE Actuator
3208 TRUCK ENGINE Air Inlet Manifold
3208 TRUCK ENGINE Crankcase Breather
D353 INDUSTRIAL & MARINE ENGINES Introduction
D353 INDUSTRIAL & MARINE ENGINES Fuel Injection Equipment
D353 INDUSTRIAL & MARINE ENGINES Fuel Transfer Pump
D353 INDUSTRIAL & MARINE ENGINES Fuel Pump And Governor Drive
D353 INDUSTRIAL & MARINE ENGINES Fuel Filter