Crankshaft Rear Seal
Usage:
Remove Crankshaft Rear Seal
start by:
a) remove flywheel
1. Remove the crankshaft rear seal with tooling (A).
Install Crankshaft Rear Seal
1. Install tooling (A) as follows:
a) Install pilot (1) on the crankshaft with bolts (2). Install ring (5) on pilot (1).
b) Put 7F2770 Cement on the outer metal surface of the seal. Install the seal on the pilot with the lip of the seal toward the front of the engine.
c) Install pusher plate (6) and ring (3) over pilot (1). Install nut (4). Tighten the nut until the ring (5) makes contact with the flywheel housing.
2. Remove tooling (A).
end by:
a) install flywheel
Caterpillar Information System:
3208 TRUCK ENGINE Flywheel
3208 TRUCK ENGINE Automatic Timing Advance
3208 TRUCK ENGINE Camshaft And Gears
3208 TRUCK ENGINE Oil Pump And Relief Valve
3208 TRUCK ENGINE Timing Gear Cover And Oil Pump
3208 TRUCK ENGINE Crankshaft Front Seal
3208 TRUCK ENGINE Crankshaft Pulley
3208 TRUCK ENGINE Pistons
3208 TRUCK ENGINE Valve Lifters
3208 TRUCK ENGINE Cylinder Heads
3208 TRUCK ENGINE Fuel Injection Nozzles
3208 TRUCK ENGINE Rocker Shafts
3208 TRUCK ENGINE Crankshaft Rear Seal Wear Sleeve
3208 TRUCK ENGINE Flywheel Housing
3208 TRUCK ENGINE Crankshaft And Gear
3208 TRUCK ENGINE Camshaft Bearings
3208 TRUCK ENGINE Reconditioning Procedures
3208 TRUCK ENGINE Systems Operation
3208 TRUCK ENGINE Testing And Adjusting
3208 TRUCK ENGINE Air Inlet Manifold
3208 TRUCK ENGINE Breather
3208 TRUCK ENGINE EGR Tube
3208 TRUCK ENGINE EGR Actuator
3208 TRUCK ENGINE EGR Valve