Flywheel
Usage:
(1) Flywheel shoulder.
(2) Install ring gear so that part No. is on this side. Ring gear must be assembled against shoulder of flywheel.
NOTE: Do not heat ring gear to more than 400° F (204° C) before installing on flywheel.
(3) Pilot bore.
(4) Torque for bolts holding flywheel to crankshaft ... 55 ± 5 lb. ft.(75 ± 7 N·m)
NOTE: Dash mark on flywheel must be in alignment with dash mark on crankshaft.
Caterpillar Information System:
3208 TRUCK ENGINE Fan Drive
3208 TRUCK ENGINE Pulley And Damper
3208 TRUCK ENGINE Crankshaft
3208 TRUCK ENGINE Piston
3208 TRUCK ENGINE Connecting Rod
3208 TRUCK ENGINE Cylinder Block
3208 TRUCK ENGINE V-Belt Tension Chart
3208 TRUCK ENGINE Water Temperature Regulator (9L6756)
3208 TRUCK ENGINE Water Pump
3208 TRUCK ENGINE Oil Pump
3208 TRUCK ENGINE Oil Level Gauge
3208 TRUCK ENGINE Lubrication System
3208 TRUCK ENGINE Mounting Group For Allison Transmission
3208 TRUCK ENGINE Flywheel Runout
3208 TRUCK ENGINE Flywheel Housing Runout
3208 TRUCK ENGINE Flywheel Housing Bore
3208 TRUCK ENGINE Alternators
3208 TRUCK ENGINE Starting Motors
3208 TRUCK ENGINE Starter Solenoids
3208 TRUCK ENGINE Shutoff Solenoid (Activated to Run)
3208 TRUCK ENGINE Air Compressor
3208 TRUCK ENGINE Systems Operation
3208 TRUCK ENGINE Testing And Adjusting
3208 TRUCK ENGINE Introduction To The Troubleshooting Guide