Usage:
(1) Fuel injection pump drive gear and timing advance unit.
(2) Camshaft gear.
NOTE: Make alignment of "V" mark as shown.
(3) Water pump drive gear.
(4) Gear for attachment drive groups.
(5) Idler gear assembly.
NOTE: Make alignment of "V" marks as shown.
(6) Bore in the bearing (new) ... 63.602 ± 0.038 mm (2.5040 ± .0015 in.)
Diameter of the shaft (new) ... 63.500 ± 0.013 mm (2.5000 ± .0005 in.)
NOTE: The groove in the gear and the groove in the bearing must not be out of alignment by more than ± 5°.
(7) End clearance (new) ... 0.15 to 0.48 mm (.006 to .019 in.)
(8) Plate. The lubrication groove must be against the gear.
(9) Crankshaft gear.
NOTE: Make alignment of "V" mark as shown.
(10) Engine oil pump drive gear.
(11) Torque for bolt ... 55 ± 7 N·m (40 ± 5 lb. ft.)