Usage:
4.1 Introduction
This chapter describes the installation of the gearboxes.
The preceding safety notes must be carefully observed.
Carefully follow the instructions given on the installation drawing: 1/6167/5201/1.
4.2 Mounting Work to be Performed
Secure the gearbox safely before removing the lifting straps or ropes.
- * Avoid heavy blows when mounting the equipment.
Make sure that axial forces are not exerted during mounting.
- * Make sure high compression forces do not act on the gearbox housing.
- * During this work observe installation drawing as well as pertinent data.
- Attach the gearbox to a crane.
- Lift the gear into the bogie frame.
- Tighten the screws using a torque wrench. The relevant tightening torques shall be taken from the frame drawing.
- Remove the lifting or ropes.
- Remove the plug (motor side) at the gearbox before connecting the hydraulic motor.
Make sure that no dirt or foreign bodies are allowed to enter the gearbox.
Mount the hydraulic motor. Carefully observe the respective instructions given by the manufacturer.
- * When mounting the hydraulic motor make sure that they are properly sealed off.
The preceding safety notes of customer must be carefully observed.
Remove the plugs before connecting the hydraulic oil lines.
Make sure that no dirt or foreign bodies are allowed to enter the hydraulic system.
- * Connect the hydraulic motor.
The preceding safety notes of customer must be carefully observed.
Check once again tight fit of all joining elements.