Usage:
NOTE: The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst.
NOTE: This Program must be administered as soon as possible. When reporting the repair, use "PI3652" as the Part Number, "7751" as the Group Number, "56" as the Warranty Claim Description Code and "T " as the SIMS Description Code. Exception: If the repair is done after failure, use "PI3652" as the Part Number, "7751" as the Group Number, "96" as the Warranty Claim Description Code, and " Z" as the SIMS Description Code.
Completion Date
March 31, 1994Termination Date
September 30, 1994Problem
The coolant lines between the engine jacket water pump and the brake oil cooler may come loose allowing a rapid loss of engine coolant on certain 994 Loaders.
Affected Product
Model & Identification Number
994 (9YF28-55)
Parts Needed
Dealers will need to order parts for this Program.
- 4 - 8C4436 Bolt
- 4 - 3E7404 Clamp-Hose
- 1 - 7N4932 Gasket
- 38 - 5P1262 cm-Hose Stock
- 2 - 7S8767 Gasket
- 2 - 8T1919 Seal
- 8 - 8T4121 Washer
- 2 - 8T4133 Nut
- 2 - 8T4136 Bolt
- 2 - 8T4196 Bolt
- 2 - 8T6767 Plug
- 2 - 6V1581 Clip
- 2 - 6V1582 Bracket
- 2 - 4W0530 Ring
- 4 - 4W0531 Retainer
- 1 - 7W7071 Gasket
- 1 - 1054277 Bonnet
- 1 - 1054278 Tube
- 1 - 1054287 Bonnet
- 1 - 1054288 Tube
- 1 - 1054317 Flange
- 1 - 1064683 Bracket
- 1 - 1064684 Bracket
- 4 - 3E7404 Clamp-Hose
Action Required
See attached rework procedure.
Owner Notification
U.S. and Canadian owners will receive the attached Owner Notification.
Service Claim Allowances
NOTE: This is a 5-hour job.
NOTE: U.S. and Canadian Dealers Only - Eligible dealers may enter a TYPE 2 SIMS Report.
Parts Disposition
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
NOTE: MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
- (1-Owner Notification)
- (2-Rework Procedure)
Attach.
Copy Of Owner Notification For U.S. And Canadian Owners
Rework Procedure
1. Remove the existing coolant lines between the engine jacket water pump outlet and the coolant inlet to the brake oil cooler.
2. Remove the coolant lines between the brake oil cooler coolant outlet and torque converter oil cooler coolant outlet.
3. Install the new parts listed below as shown in the illustration.
LOCATION OF NEW BRAKE OIL COOLER LINES