1982/05/12 Caterpillar


Be Sure To Use Correct Water Temperature Regulator

Usage:


3208 Industrial And Marine Engines

Water temperature regulators (or regulator kits) used on earlier 3208 Industrial and Marine Engines must not be used on later 3208 Engines. The earlier regulators have pilot "fingers" on the ends, which become damaged when installed on later engines. Later regulators use a flat plate on the end and can be installed on all earlier or later 3208 Industrial and Marine Engines. See the illustration.

Earlier and later water temperature regulators can be used on 3208 Industrial and Marine Engines as shown in the chart which follows:


Earlier and later water temperature regulators.

Caterpillar Information System:

1982/05/12 Bolts Now Used Instead Of Studs To Hold Cylinder Heads
1982/05/12 Inspection Marks On Bearings
1982/05/12 New Mounting Bracket For Mechanical Shut-Off Cable
1982/05/12 Expansion Tank Changed To Permit Installation Of Water Level Gauge
1982/05/12 Improved Plunger And New Spring Used In Mechanical Shutoff Group
1982/05/12 6V4960 AC Current Probe Will Measure Current Easier
1982/05/12 New 6V4950 Injection Line Speed Pickup Group Used With 6V2100 Multitach
1982/05/12 5P3519 Gauge Group Components Available Separately
1982/05/12 Improved Relief Valve Guide Decreases Maximum Oil Pressure During Cold Weather Starts
1982/05/12 Lubricant Recommendations Changed For All Caterpillar Engines To Combat Effects Of Fuel Sulfur
1982/05/12 Use New 6V4910 Clamp-On Ammeter For Easier Electrical Current Measurement
1982/05/12 New Crankshaft Main Bearings Used
1982/05/12 Two-Piece Guard For Alternator Fan And Belts
1982/06/16 Improvements Made To Input Shaft Group
1982/06/16 List Of Main And Connecting Rod Bearings Currently Available
1982/06/16 Improved Water Separator Group Used
1982/06/16 New, Improved Impeller Used In Water Pump
1982/06/16 Larger Studs Can Be Used With Rear Exhaust Manifolds
1982/06/16 List Of Service Publications
1982/06/16 Carbon Cutting On Piston Top Land
1982/06/16 New Address For Repair Of Diagnostic Tools
1982/06/16 New Exhaust Tubes And Support Used
1982/06/16 Avoid Overheating Of Rear Power Take Off Clutches
1982/06/16 New Seal Used In Turbocharger Mounting; Check Mount Casting For Clearance
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.