1981/11/25 Caterpillar


Use Of Metric Fasteners

Usage:


All Caterpillar Engines Used In Original Equipment Manufacturer (OEM) Applications

Metric fasteners are now used by some OEM companies in the assembly of their equipment. Caterpillar uses only U.S. Standard fasteners on its engines. Servicemen that work on OEM equipment must remember that it is possible to find both metric and U.S. Standard fasteners on these products. Make sure the correct tools are used for the fasteners on your machines.

Caterpillar Information System:

1981/11/25 Check Bottom Surface Of Cylinder Liner Flange For Erosion And Wear
1981/11/25 New Basic Turbocharger Group Prevents Possible Failures Of Compressor Wheel
1981/11/25 List Of Service Publications
1981/11/25 New Clearance Specifications For Oil Pump Rotor Tip
1981/11/25 Improved Element Assemblies Used In Jacket Water Heaters
1981/11/25 Reference Chart For Major Production Changes On 3208 Engines
1981/11/25 New Parts And Assembly Procedure Used On Main Shaft
1981/11/25 Part Number For Fuel Injection Pump Group In New Location
1981/11/25 New Regulator And Field Coil Assemblies Used
1981/10/21 New Cylinder Block Permits Use Of A Small-Frame Turbocharger
1981/10/21 Use Of Engine Supports On Flywheel Housing Can Change Face And Bore Runout Measurements
1981/10/21 Service Manual Information About Inside Diameters Of Valve Guides
1981/11/25 New Shaft Assembly Used In Flexible Coupling Arrangement
1981/12/16 New Spacer; New Shaft Assembly Permits Pressure Lubrication Of Sun Gear
1981/12/16 New Springs For Timing Advance Used In Governor And Fuel Pump Drive Group
1981/12/16 New 6V4190 Auto Programmer Group And 6V4865 Auto Programmer Connector Used With 6V2100 Multitach
1981/12/16 New Air Cleaner Group Has Six Clamps For Improved Seal
1981/12/16 How To Remove The 7L4511 Sleeve Assembly From Aftercoolers
1981/12/16 New Tube And Cover Assembly Make Service Easier
1981/12/16 New Cylinder Liners And O-Ring Seals Give Longer Seal Life
1981/12/16 Make Sure Coolant Conditioner Elements Are Changed At Correct Intervals
1981/12/16 Plate Added To Hold Oil Lines In Adapter For Left Side Oil Filter
1982/01/20 Use FT1555 Generator Rotor Removal Tool To Remove And Install Rotor Assembly
1982/01/20 New Torque Specification For Bushing
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.