1981/07/15 Caterpillar


Ring Now Used To Hold Bearing In Auxiliary Drive Group

Usage:


3408 Industrial And Marine Engines

Description of Change: A ring has been added to the auxiliary drive group (right hand rear) for 3408 Industrial And Marine Engines.

The ring has been added on the shoulder of the gear. It will not let the bearing slide off the gear.

Formerly, no ring was used; the bearing had a press fit. At times, it was possible for the bearing to move off the shoulder of the gear.

Adaptable To: The 8J8322 Ring is adaptable to the 4N8505 Auxiliary Drive Group on all 3408 Industrial and Marine Engines.


Location of the 8J8322 Ring.

Caterpillar Information System:

1981/07/15 Use 6V4068 Tool Group To Machine Camshaft Thrust Face
1981/07/01 Troubleshooting Water In Shut-Off Solenoid Housing
1981/07/01 Larger Air Cleaner Used For Less Restriction To Air Flow
1981/07/01 New Service Meter Used In Mechanical Shutoff Group
1981/07/01 List Of Service Publications
1981/07/01 New Gasket Used For End Cover On Inlet Manifold
1981/07/01 New Gasket Used In Front Housing Group
1981/07/01 New Seals And Clutch Discs Used
1981/07/01 Instruction Cards For "Go-No Go" Gauges Now Available
1981/07/01 Inspect Piston Skirts During Engine Overhaul Procedures
1981/07/01 Correct Use Of Keystone Ring Groove Gauges
1981/07/01 6V3145 Leveler Now Available
1981/07/15 New Turbocharger, Turbocharger Oil Line And Aftercooler Air Lines Group Used
1981/07/15 Stronger Fitting Used With Sending Unit For Oil Pressure Gauge
1981/07/15 All Size Identification Marks On Engine Bearings Are Now Shown In Millimeters
1981/07/15 Remove Piston Cooling Tubes Before Removal Of Pistons And Connecting Rods
1981/07/15 New Retainers Used To Hold Oil Pump Output Tube In Manifold
1981/07/15 Mailing Of Engine News And Truck Engine News Microfiche Libraries
1981/07/15 Use 6V4172 Injector Sleeve When You Clean Fuel Injectors
1981/07/15 6V4133 Wedge Bracket Makes Cylinder Liner Removal Easier
1981/07/15 Procedure To Stop Lubricant Leakage From Flexible Couplings
1981/07/15 Use 6V4828 Snap Ring Pliers To Remove Snap Rings From Turbocharger Housing
1981/07/15 Single Connector Prevents Leakage From Fuel Filter Lines Groups
1981/08/26 New Spanner Wrenches Needed To Install Bearings On Marine Transmission Shafts
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.