Use Correct Specifications To Check Piston Ring Gaps
Usage:
D343, D346, D348, And D349 Engines
- SUPPLEMENT: 07/01/81
ENGINE NEWS, JUNE 3, 1981, PAGE 2.
In the article "Use Correct Specifications To Check Piston Ring Gaps," the chart has an error. The chart which follows has the correct ring gap specifications.
--------------- END SUPPLEMENT ---------------
Be sure to use correct specifications to check the ring gap in the above engines. The ring gaps must be checked while inside a new liner with a bore of 5.400". Correct ring gap specifications are given for both rectangular ring and Keystone piston ring designs in the chart which follows.
The ring gap will increase 0.08 mm (.003") for each 0.03 mm (.001") increase in the bore size.
Caterpillar Information System:
1981/06/03 Replacement Bushings For Delco-Remy Electric Starting Motors Must Be Machined For Correct Clearances
1981/05/20 Washer Added Between Bolt And Thrust Plate For Oil Pump Idler Gear
1981/05/20 Hardened Nuts And Higher Torque Now Used In Ahead And Astern Clutch Groups
1981/05/20 Use 6V4089 Reamer Assembly To Clean Nozzle Bores
1981/05/20 Installation Of Rear Bearing Oil Seals In 3N6542, 3N8617, And 3N8618 Rear Power Takeoff Clutch Groups
1981/05/20 Different Check Valve Gives Faster Shifts
1981/05/20 List Of Service Publications
1981/05/20 Larger Valve Springs
1981/05/20 6V4020 Piston Ring Expander Group Available
1981/05/20 Crankshaft Failures; New Thrust Plate
1981/05/20 New Tool Makes Glow Plug Wire Removal Easier
1981/05/20 Safety: Battery Vent Caps
1981/06/03 New Cover Assembly And Gasket Used In Oil Pump Group
1981/06/03 Locks No Longer Used On Flywheel Bolts; New Torque Specifications For Flywheel Bolts
1981/06/03 New Mounting Group For Overspeed Switch
1981/06/03 Remove Direct Injection Fuel Nozzles With 6V4061 And 6V4054 Nozzle Pullers
1981/07/01 6V3145 Leveler Now Available
1981/07/01 Correct Use Of Keystone Ring Groove Gauges
1981/07/01 Inspect Piston Skirts During Engine Overhaul Procedures
1981/07/01 Instruction Cards For "Go-No Go" Gauges Now Available
1981/07/01 New Seals And Clutch Discs Used
1981/07/01 New Gasket Used In Front Housing Group
1981/07/01 New Gasket Used For End Cover On Inlet Manifold
1981/07/01 List Of Service Publications