Use 6V4089 Reamer Assembly To Clean Nozzle Bores
Usage:
3100, 3200 and 3300 Series Engines With Direct Injection
Carbon deposits can make it very difficult to remove fuel injection nozzles. Two factors that increase carbon deposits in the nozzle bores are:
-
- 1. The installation of a nozzle that has a damaged carbon dam.
- 2. Damage to a good carbon dam caused by the installation of the nozzle into a bore with carbon build-up present.
- 1. The installation of a nozzle that has a damaged carbon dam.
The new 6V4089 Reamer Assembly is available to remove these carbon deposits. The reamer assembly is rotated with an open end wrench or tap driver. When used correctly the reamer will not remove metal from the nozzle bores.
6V4089 Reamer Assembly
Caterpillar Information System:
1981/05/20 Installation Of Rear Bearing Oil Seals In 3N6542, 3N8617, And 3N8618 Rear Power Takeoff Clutch Groups
1981/05/20 Different Check Valve Gives Faster Shifts
1981/05/20 List Of Service Publications
1981/05/20 Larger Valve Springs
1981/05/20 6V4020 Piston Ring Expander Group Available
1981/05/20 Crankshaft Failures; New Thrust Plate
1981/05/20 New Tool Makes Glow Plug Wire Removal Easier
1981/05/20 Safety: Battery Vent Caps
1981/05/20 Change Made To Power Take-Off Adapter Housing
1981/05/20 Replacement Thermostat, Element Assemblies Available For Jacket Water Heater
1981/05/20 Remove And Install Cam Bearings With 6V4077 Cam Bearing Tool Group
1981/05/20 Use 6V4069 Body Group To Remove Tapered Drive Sleeve
1981/05/20 Hardened Nuts And Higher Torque Now Used In Ahead And Astern Clutch Groups
1981/05/20 Washer Added Between Bolt And Thrust Plate For Oil Pump Idler Gear
1981/06/03 Replacement Bushings For Delco-Remy Electric Starting Motors Must Be Machined For Correct Clearances
1981/06/03 Use Correct Specifications To Check Piston Ring Gaps
1981/06/03 New Cover Assembly And Gasket Used In Oil Pump Group
1981/06/03 Locks No Longer Used On Flywheel Bolts; New Torque Specifications For Flywheel Bolts
1981/06/03 New Mounting Group For Overspeed Switch
1981/06/03 Remove Direct Injection Fuel Nozzles With 6V4061 And 6V4054 Nozzle Pullers
1981/07/01 6V3145 Leveler Now Available
1981/07/01 Correct Use Of Keystone Ring Groove Gauges
1981/07/01 Inspect Piston Skirts During Engine Overhaul Procedures
1981/07/01 Instruction Cards For "Go-No Go" Gauges Now Available