1981/05/20 Caterpillar


Replacement Thermostat, Element Assemblies Available For Jacket Water Heater

Usage:


All Caterpillar Engines Equipped With 5N5739 And 5N5740 Jacket Water Heaters

The thermostat and element assemblies used in the 5N5739 and 5N5740 Jacket Water Heater are now available for parts service.

The 5N8568 Thermostat is available for use in both of these water heaters. The 5N8566 Element Assembly is available for use in the 5N5739 Jacket Water Heater (120 volt). The 5N8567 Element Assembly is available for use in the 5N5740 Jacket Water Heater (240 volt).

Caterpillar Information System:

1981/05/20 Remove And Install Cam Bearings With 6V4077 Cam Bearing Tool Group
1981/05/20 Use 6V4069 Body Group To Remove Tapered Drive Sleeve
1981/04/22 6V3197 Spacer, 6V3041 Tool Group Available For Use During Removal And Installation Of Piston Pin Bearings
1981/04/22 Improve Use Of Engine Service Manual Microfiche
1981/04/22 List Of Service Publications
1981/04/22 New Spacer And Plate Used In Transmission Lower Shaft Groups
1981/04/22 Woodward Governor Available For Parallel Generator Applications
1981/04/22 Check Operation Of Hydramechanical Shutoff At Specific Intervals
1981/04/22 6V3150 Engine Pressure Group Gives Direct Indication Of Manifold Pressure
1981/04/22 FT1585 Plate Can Be Fabricated For Governor Spring Guide Replacement
1981/04/22 New Ahead Main Shaft Assembly Gives A Tighter Fit; Dimensions For The Fit Of Shafts And Gears
1981/04/22 New Piston Ring Assemblies Give Improved Ring And Cylinder Liner Life
1981/05/20 Change Made To Power Take-Off Adapter Housing
1981/05/20 Safety: Battery Vent Caps
1981/05/20 New Tool Makes Glow Plug Wire Removal Easier
1981/05/20 Crankshaft Failures; New Thrust Plate
1981/05/20 6V4020 Piston Ring Expander Group Available
1981/05/20 Larger Valve Springs
1981/05/20 List Of Service Publications
1981/05/20 Different Check Valve Gives Faster Shifts
1981/05/20 Installation Of Rear Bearing Oil Seals In 3N6542, 3N8617, And 3N8618 Rear Power Takeoff Clutch Groups
1981/05/20 Use 6V4089 Reamer Assembly To Clean Nozzle Bores
1981/05/20 Hardened Nuts And Higher Torque Now Used In Ahead And Astern Clutch Groups
1981/05/20 Washer Added Between Bolt And Thrust Plate For Oil Pump Idler Gear
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.