Some Remanufactured 3406 Engines Have The Wrong Reference Serial Number On The Identification Plate
Usage:
A remanufactured serial number and a reference serial number are put on the identification plate of remanufactured 3406 Engines. The reference serial number permits the selection of the correct parts book for a specific engine. Some of the reference serial numbers put on early remanufactured 3406 Engines are not correct. The identification plates have the correct serial numbers, starting with the serial numbers shown in the chart which follows:
If you have a remanufactured 3406 Engine with a wrong reference serial number on the plate, a plate with the correct serial number can be ordered at no cost from:
Parts and Service Sales G.O., AB5D
Attention: Remanufacturing Section
Peoria, IL 61629
(309) 675-5100
NOTE: If a corrected plate is desired, be sure the remanufactured serial number of your engine is sent with the order.
Caterpillar Information System:
1980/12/10 6V4008 Valve Seat Extractor Now Available
1980/11/12 Rack Shut-Off Solenoid Can Be Removed And Engine Started When There Is An Emergency
1980/11/12 Two Replacement Lights Available For 5P7277 Voltage Tester
1980/11/12 A Group Of Special Instructions On The Subject Of Alignment Is Currently Available
1980/11/12 6V3147 Main Bearing Wrench Now Available
1980/11/12 List Of Service Publications
1980/11/12 Modification Of Puller Bolt Prevents Thread Damage During Removal Of Sleeve From Sleeve Metering Fuel System
1980/11/12 Improved Cable Assembly For Mechanical Shut-Off Group
1980/11/12 Coolant Conditioner Elements Are Now Available For 3208 Engines
1980/11/12 Check For Correct Spring Retainer On Oil Pump Bypass Valve When Oil Pan Is Removed
1980/11/12 Inspect All Engine Oil And Fuel Filter Elements Before Installation
1980/11/12 Check Valve Added To Hydramechanical Shut-Off
1980/12/10 New Front Housing Assembly And Gaskets Used
1980/12/10 6V4021 Piston Ring Compressor Group Available
1980/12/10 New Gasket Improves Operation Of Shut-Off Groups
1980/12/10 Two Thinner Spacers Available For Use During Adjustment Of Off-Engine Timing Dimension
1980/12/10 Different O-Ring Seal Now Used On The Oil Pump Suction Tube
1980/12/10 Use Fluid-Type Vibration Damper To Control Vibrations
1981/01/21 New Control Valve Group Used To Prevent Ratchet-Type Noise And Rough Clutch Engagement
1981/01/21 Improvements Made To 5P9718 And 6V186 Disc Pads Used During Gasket Removal
1981/01/21 New Connecting Rod And Main Bearings Have A Thicker Coating (Layer) Of Lead-Tin Overlay
1981/01/21 6V4019 Camshaft Pilot Group Is Available
1981/01/21 New Bearing Sizes And Identification Codes For AiResearch Remanufactured Turbocharger Cartridges
1981/01/21 Larger Plug Used In The Ends Of The Rocker Arm Shaft Assembly