List Of Service Publications
Usage:
This service information has become available since the last list published in the February 6, 1980 issue of Engine News. These forms can be ordered from your Caterpillar dealer to keep reference information current.
Caterpillar Information System:
1980/03/12 Spacer Plate Block Group Used For Parts Service Of Block Group With Counterbore Design
1980/03/12 New Fuel Injection Lines And Clamps Prevent Stresses And Contact Which Can Cause Leakage
1980/03/12 Stronger Braces Used Between Air Cleaner And Engine
1980/03/12 Connecting Rod Changes And Replacement Information
1980/03/12 Visual Inspection Of Main And Connecting Rod Bearings
1980/03/12 Inspect Regulator Cover Assembly When Overcooling Is A Problem
1980/02/27 Plunger Movement Must Be Adjusted When New Rack Shut-Off Solenoid Is Installed
1980/02/27 Warning: Avoid Use Of Fuel Mixtures Of High Volatility. If You Are Exposed To Such Mixtures, Be Aware Of The Hazards Involved And Take Proper Precautions
1980/02/27 How To Check Operation Of Hydramechanical Shutoffs On D379B, D398B, D399 Engines
1980/02/27 New Attachment Air Compressor Group and Lines Groups Have Improved Design
1980/02/27 New Piston Groups Have The Piston Pin Bore Off-Center, Away From The Thrust Side Of The Piston
1980/02/27 Identification Of Fuel Injection Lines And Nozzle Bodies For Different Combustion Systems
1980/03/12 Crankshaft Rear Seal And Wear Sleeve Are Now Serviced As A Group Instead Of Separate Parts
1980/03/12 New Control Valve Body
1980/04/09 6V2023 Flow Check Adapter Group Is Available
1980/04/09 Dowtherm 209 Full-Fill Coolant
1980/04/09 Different Water Temperature Regulators Now Used To Prevent Overheating
1980/04/09 Remanufactured Short Blocks Are Available For Repairs Of Early 3406 Engines
1980/04/09 Important: Use Only 12 Volts Direct Current To Boost Start 3208 Truck Engines Equipped With Exhaust Gas Recirculation Systems
1980/04/09 Caution: Outboard Bearing Must Be Removed From Extended Shaft Of Front Power Takeoff Before The Engine Is Moved
1980/04/30 Main And Connecting Rod Bearings With Cavitation Erosion Can Be Used Again
1980/04/30 Wrong Installation Of Oil Cooler Gasket Can Cause High Oil Temperatures
1980/04/30 Boring Machine, Adapter Groups And Sleeves Available For Repair Of Damaged Cylinder Blocks
1980/04/30 Crankcase Capacity Increased And New Oil Level Gauges Used; Specifications For Conversion Of Existing Gauges