1979/09/19 Caterpillar


New Gasket Used In Water Lines Group For Aftercooler

Usage:


3306 Engines

Description of Change: A different gasket is now used in the water lines group for the aftercooler on 3306 Engines. The location of this gasket is at the oil cooler bonnet outlet. The new gasket has a 1.22" (30.99 mm) diameter opening. The former gasket had a .9" (22.9 mm) diameter opening. It was possible for the water to break small pieces off the former gasket. These pieces some times cause a restriction in the aftercooler and other small passages in the cooling system.

Adaptable As: The 2A3541 Gasket is a direct replacement for the 1F4738 Gasket in this application.


Location of the 2A3541 Gasket in the water lines group.

Caterpillar Information System:

1979/09/19 Electrical System Voltage Must Be Limited To A Maximum Of 40 Volts With Woodward Model 2301 Governors.
1979/09/19 New Bracket Available For Installation Of Jacket Water Heater
1979/09/19 Service Kit Is Available For Woodward UG8 Governor
1979/09/19 Pin Bore Is Now Offset (Not In The Center) .059" (1.5 mm) In The Piston To Stop Vibration Of The Cylinder Liners Which Can Cause Pitting On The Coolant Side Of The Cylinder Liners
1979/09/19 New Main And Connecting Rod Bearings Have A Thicker Layer Of Surface Material
1979/09/19 Tee Handle Hexagonal Wrench In Rack Adjusting Tool Is Now Available For Parts Replacement
1979/09/19 Keystone Piston Groups Can Be Installed In Earlier Engines In Steiger Tractors
1979/09/19 Different Grease Fitting Now Used In Fan Drive Group
1979/09/19 6V190 Clamp Is Available For Use On Sleeve Metering Fuel Systems
1979/09/19 Engines Can Use Crankshafts With Either Six Or Eight Counterweights
1979/08/22 New Rocker Arms And Rocker Arm Shaft Have Improved Lubrication
1979/08/22 List Of Service Publications
1979/09/19 New BrakeSaver Control Valve Group Has Improved Diaphragm
1979/09/19 Cranking Speeds Necessary To Start Diesel Engines
1979/09/19 Raw Water Pump Improved
1979/09/19 Stronger Bolt Now Used With Exhaust Manifold
1979/09/19 New Liner Seat Inserts For Spacer Plate Cylinder Blocks Are Made Of Stainless Steel
1979/09/19 Improved Sea Water Pump Now Used
1979/09/19 6V2055 High Vacuum Grease Gives Better Oil Seal
1979/10/03 Quick Disconnect Coupling On Optional Modification Of 5P4150 Nozzle Tester Permits Faster Exchange Of Adapters
1979/10/03 Steel Plates Are Now Used To Hold The Element In Position In The Panel-Type Air Cleaner Housing Assembly
1979/10/03 Different Mounting Hole Locations In Ring Gear Plate Assembly And Rotor Assembly For BrakeSaver
1979/10/03 List Of Service Publications
1979/10/03 Tips For SIRS (Service Information Retrieval System) Users
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.