Tee Handle Hexagonal Wrench In Rack Adjusting Tool Is Now Available For Parts Replacement
Usage:
The 6V115 Tee Handle Hexagonal Wrench, which is a part of the 5P7335 Rack Adjusting Tool, is now available for parts replacement. The initial (first) quantities of the tee handle hexagonal wrench will be 6.5" (165.1 mm) in length. Later, the length will be changed to 9" (228.6 mm). Later 5P7335 Rack Adjusting Tools will have the 9" (228.6 mm) wrench. The 6V115 Wrench is directly adaptable to applications which need this type of wrench.
NOTE: When a 6V115 Wrench is used with the 5P7335 Rack Adjusting Tool to set the rack on some engines, it must be 6.5" (165.1 mm) in length because of limited clearances. For this reason, it is best to have both a 6.5" (165.1 mm) and a 9" (228.6 mm) length 6V115 Wrench available.
Caterpillar Information System:
1979/09/19 Keystone Piston Groups Can Be Installed In Earlier Engines In Steiger Tractors
1979/09/19 Different Grease Fitting Now Used In Fan Drive Group
1979/09/19 6V190 Clamp Is Available For Use On Sleeve Metering Fuel Systems
1979/09/19 Engines Can Use Crankshafts With Either Six Or Eight Counterweights
1979/08/22 New Rocker Arms And Rocker Arm Shaft Have Improved Lubrication
1979/08/22 List Of Service Publications
1979/08/22 Sealant Now Used On Pipe Plugs At The Bottom Of The Oil Filter Base Assembly To Prevent Oil Leakage
1979/08/22 New Cylinder Head Gasket Has Smaller Diameter Cylinder Openings To Improve Location Of Combustion Seal Ring
1979/08/22 New Design Thrust Plate Used In Crankshaft Group
1979/08/22 Only One Dowel Pin Is Now Used To Hold The Thrust Bearing In The Correct Position
1979/08/22 Exhaust Manifold And Air Lines Groups Changed To Prevent Exhaust Leakage
1979/08/22 New Seal Used Under Retaining Bushing For Fuel Injection Pump Bonnet
1979/09/19 New Main And Connecting Rod Bearings Have A Thicker Layer Of Surface Material
1979/09/19 Pin Bore Is Now Offset (Not In The Center) .059" (1.5 mm) In The Piston To Stop Vibration Of The Cylinder Liners Which Can Cause Pitting On The Coolant Side Of The Cylinder Liners
1979/09/19 Service Kit Is Available For Woodward UG8 Governor
1979/09/19 New Bracket Available For Installation Of Jacket Water Heater
1979/09/19 Electrical System Voltage Must Be Limited To A Maximum Of 40 Volts With Woodward Model 2301 Governors.
1979/09/19 New Gasket Used In Water Lines Group For Aftercooler
1979/09/19 New BrakeSaver Control Valve Group Has Improved Diaphragm
1979/09/19 Cranking Speeds Necessary To Start Diesel Engines
1979/09/19 Raw Water Pump Improved
1979/09/19 Stronger Bolt Now Used With Exhaust Manifold
1979/09/19 New Liner Seat Inserts For Spacer Plate Cylinder Blocks Are Made Of Stainless Steel
1979/09/19 Improved Sea Water Pump Now Used