Shorter Bolt Used In BrakeSaver Manifold To Prevent Possible Contact With Bolt In Transmission
Usage:
3406 Truck Engines (92U);
3408 Truck Engines (28V)
Description of Change: A shorter bolt is now used to hold the BrakeSaver manifold to the BrakeSaver housing on 3406 and 3408 Truck Engines. The use of this shorter bolt in the manifold will prevent possible contact with the body of a transmission retainer bolt which extends through the BrakeSaver housing.
Adaptable As: The new 1A2029 Bolt is a direct replacement for the former S1588 Bolt at the location shown in the Illustration.
Location of parts.
Caterpillar Information System:
1979/06/20 Inspection Of Air Inlet 9L7630 Gaskets
1979/06/20 List Of Service Publications
1979/06/20 During Installation Of An Auxiliary Bypass Oil Filter, Be Sure Passage In Oil Cooler Fitting Is Open
1979/06/20 New "L-Shaped" Clutch Plates Now Used
1979/06/06 Inspection Of Parts Stocks Of 9L9200 Oil Filters
1979/06/06 New Washers For Injection Valve Nozzles Must Be Added To Valve Grinding Gasket Kit When Used With Later Engines
1979/06/06 9S8100 Tool Group Changed To Use With Fuel Transfer Pump Only
1979/06/06 Correct Locations To Connect Gauges For Checks Of Engine Oil Temperature And/Or Pressure
1979/06/06 New Centering Rings For Oversized Main Bearings
1979/06/06 New Type Products Available To Clean Cooling Systems
1979/06/06 Check Crankshaft Seals During Installation Of Engine Overhaul Gasket Kits; Add A Wear Sleeve When Needed
1979/06/06 A New Method To Clean And Polish Engine Valve Stems
1979/06/20 New Specification For Installation Of Camshaft Front Bearing In Cylinder Block
1979/06/20 Test Specifications Now Available For 9N3979 And 9N2366 Pencil Type Fuel Nozzle Assemblies
1979/06/20 Rod Bearings For Parts Service Have Reliefs (Grooves) Cut On The Outside Diameter
1979/07/04 6V117 And 6V2001 Bushings Used In 9S8140 Pressurizing Pump Group Are Available For Parts Service
1979/07/04 Temperature Compensator Conversion Group Available For Fuel System To Prevent Low Power Output
1979/07/04 Improved Engine Design Uses Cylinder Block With Spacer Plate And New Crankshaft Thrust Plates
1979/07/04 New Air Inlet Tube Gives Enough Room To Install A "Jake Brake"
1979/07/04 Caution Label Added To 5P4150 Nozzle Testing Group
1979/07/04 Longer Life Seal And Washer Available For Certain Water Pumps In Parts Stocks
1979/07/04 6V183 Gasket Now Available For Parts Service To Use On 5P4150 Or 8S2242 Nozzle Tester
1979/07/04 Use Of 9S3265 Retaining Compound On Schwitzer Turbocharger Compressor Wheel Retainer Nuts
1979/07/04 Engine Front Support Now Machined To Prevent Possible Failure Of The Support Brackets For The Power Takeoff