1983/11/23 Caterpillar


Valve Damage Can Be Caused By Short Intervals Of Engine Operation In Very Cold Temperatures

Usage:


All Truck Engines

According to field reports, some customers have had problems with damage to engine valve components during operation in very cold temperature conditions. These problems are the result of engine operation for short intervals, where the engine is started and stopped many times but does not run long enough to become completely warm.

During the interval of time that the engine operates at temperatures below normal, fuel and oil are not completely burned in the combustion chambers. This fuel and oil causes soft carbon deposits on the valve stems. Generally, these deposits do not cause problems because they are burned off during operation at normal engine temperatures. When the engine is started and stopped at short intervals, and the engine temperature is never up to normal, the carbon deposits become thicker until they prevent free operation of the valves. This can cause burnt valves, bent push rods, or other damage to valve components.

For this reason, any time the engine is started, the recommendation is to run the engine until the coolant tmeperature is 66 °C (150°F) or higher. This will keep carbon deposits on the valve stems at a minimum.

In addition, operation of the engine until it is thoroughly warm will keep the other engine parts in better condition and generally extend the service life of the engine. Lubrication will be improved, with less acid and sludge in the oil. This will give longer service life for engine bearings, piston rings, and other parts.

Caterpillar Information System:

1983/11/23 Explanation Of Engine High Idle RPM And Correct Adjustment Of Engine Setpoint
1983/10/05 List Of Service Publications
1983/10/05 Use 6V6070 Tool Group And New Adjustment Procedure For New Scroll Fuel System
1983/10/05 Parts Service Information For Pistons, Connecting Rods, Piston Pins And Rings
1983/10/05 New Piston Oil Rings
1983/10/05 Oil Shield And Rotocoil Must Be Installed Together For Acceptable Oil Control
1983/10/05 6V3100 Engine Timing Indicator Group May Have 6V7910 Or 6V2192 Transducer
1983/10/05 Repair Of Damaged Threads
1983/10/05 Improved Governor Control Shaft And Seal Will Help Prevent Oil Leakage
1983/10/05 Vent Hole In Water Temperature Regulator Cover Removed
1983/08/31 Reference Chart For Truck Engine News Articles On Improvements To 3306 Truck Engines
1983/08/31 Recommendations For Use Of 6V6125 Infrared Thermometer
1983/11/23 New Water Temperature Regulator Has Higher Setting For Cold Weather Operation
1983/11/23 Use 6V6070 Tool Group And New Adjustment Procedure For New Scroll Fuel System
1983/11/23 New Valve Lifter Assemblies Used In Valve Mechanism Groups
1983/11/23 Maintenance Free Battery Available For Use In On-Highway Trucks And Buses
1983/11/23 New Service Centers For 6V3100 Engine Timing Indicator Group
1983/11/23 List Of Service Publications
1983/11/23 Broken Edge Filter Or Plugged Cylinder Head Adapter Can Cause Rough Engine Operation Or Low Power
1983/11/23 New Connecting Rod And Main Bearings Used
1983/12/21 Service Information For Balancers And Dampers
1983/12/21 Reuse Of Engine Bearings
1983/12/21 Crankshaft Failures
1983/12/21 Correct Installation Of New Valve Springs
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.