1983/05/18 Caterpillar


New Specification For Adjustment Of Jacobs Engine Brake

Usage:


All 3406 Truck Engines So Equipped

There has been a change to the specification for the adjustment of the slave piston for the Jacobs Engine Brake, when used on 3406 Truck Engines. The slave piston lash setting of 1.52 mm (.060 ") is now used on all 3406 Truck Engines equipped with a Jacobs Engine Brake.

Formerly, two settings were used, one for the 360 horsepower PCTA engine, and one for all other engines. The setting of 1.52 mm (.060 "), which was used on 360 horsepower PCTA engines, is now used for all engines.

Make a note of this change in your Service Manual.

Caterpillar Information System:

1983/05/18 New Fuel Setting Information
1983/05/18 Eight Good Reasons To Convert Your 3406 Truck Engine From Pc To Di At Overhaul Time{1250,1000}
1983/05/18 New Gasket And Cover Used On Governors
1983/05/18 New Fuel Nozzle Adapters Used
1983/05/18 New Specification For Clearance Between Fuel Rack Slot And Cross Link
1983/04/13 New Connecting Rod Bearings Used
1983/04/13 List Of Service Publications
1983/04/13 Use The 6V5000 Infrared Thermometer Group To Measure Temperatures
1983/04/13 Use FT1783 Fixture To Drill Vent Holes In Impeller
1983/04/13 Oil Passage Plugs Are No Longer Installed In Crankshaft For Parts Service
1983/04/13 Additions To Reference Chart For Major Production Changes
1983/04/13 Fabricated Bracket Decreases Stress On Refrigerant Compressor Bracket
1983/05/18 Installation Of Bearing For Connecting Rod Piston Pin
1983/05/18 Selection Of The Correct Battery For Use With Diagnostic Tools
1983/05/18 Valve Spring Retainers Now Have Thicker Flanges
1983/05/18 List Of Changes To Brakesavers
1983/05/18 Reuse Of Engine Bearings
1983/05/18 Procedure To Clean Oil Passages In Crankshafts And Cylinder Blocks
1983/05/18 New Special Instruction Available For 6V4135 Halogen Leak Detector
1983/05/18 Use 6V7777 Spacer With 9S6030 Front Oil Seal Installer
1983/05/18 New Turbocharger Has Thicker Mounting Flange To Prevent Breakage
1983/06/29 New Service Tools Available
1983/06/29 Use The 6V4930 Battery Load Tester To Test Batteries
1983/06/29 Consist Lists Now Available For Conversion Of Direct Injection 3406 Truck Engines To Higher Horsepower Arrangements
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.