Later Pistons Have A Smaller Number Of Drain Holes In Oil Ring Groove
Usage:
3406, 3408 Truck Engines
Some dealers have desired information about a change which was made to pistons for the 3400 Series Engines. The piston design was changed to use a total of four oil drain holes in the bottom ring groove, in comparison with the fourteen holes formerly used. The four holes are drilled only at the sides of the piston body, two holes on each side. This change in the number of drain holes has no effect on engine oil consumption.
Caterpillar Information System:
1981/03/06 New Turbocharger, Turbocharger Oil Lines Group And Aftercooler Air Lines Group Used
1981/03/06 High Concentration Of Aluminum In Oil Analysis Can Be The Result Of Rocker Arm Support Wear
1981/03/06 List Of Service Publications
1981/03/06 Changes Have Been Made To Caterpillar Service Literature
1981/02/04 New, One-piece Valve Lifter Used
1981/02/04 Inspection And Test Procedures To Follow When Fuel Ratio Control Does Not Operate Correctly
1981/02/04 Different O-ring Seal Now Used On The Oil Pump Suction Tube
1981/02/04 New Front Housing Assembly And Gaskets Used
1981/02/04 6V3150 Engine Pressure Group And 6V3121 Multitach Group Are Available For Testing Engines
1981/01/23 List Of Service Publications
1981/01/23 Purchase 3208 And 3406 Truck Engine Operation Guides, Parts Books And Service Manuals Directly From Caterpillar
1981/01/23 Wrong Turbocharger Group Shown In Parts Book
1981/03/06 Modification Of Flywheel Prevents Loose Clutch Pilot Bearing
1981/03/06 Do Not Adjust The Fuel Setting Or High Idle Higher Than Necessary
1981/03/06 Two New Exhaust Manifolds Available For Replacement Of Single Rear Manifold To Prevent Broken Studs
1981/03/06 Check Oil Level Carefully To Prevent Operation With Too Much Oil In Engine Crankcase
1981/03/06 New O-ring Seal Used In Egr (exhaust Gas Recirculation) Control Has Better Resistance To Heat Damage
1981/03/06 New Governor Spring Available For Specific Engine Applications
1981/04/09 Low Engine Temperatures: Install Check Valve
1981/04/09 6V4163 Bit And 6V4164 Driver Now Available For Removal Of Bolts For Flyweight Carrier
1981/04/09 Correction To Torque Specification For Locknuts On Valve Clearance Adjustment Screws Of Engines Equipped With Jacobs Engine Brakes
1981/04/09 Special Studs And Nuts Available For Exhaust Manifolds On Engines Used In Heavy Load Conditions
1981/04/09 Two New Oil Filter Assemblies Available; Always Use Correct Oil Filter And Follow Caterpillar Change Intervals
1981/04/09 Cooling System Cleaner Removes Rust And Corrosion