PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER Caterpillar


Introduction

Usage:

------ WARNING! ------

Read this entire manual and all other publications pertaining to the work to be performed before installing, operating, or servicing this equipment. Practice all plant and safety instructions and precautions. Failure to follow instructions can cause personal injury and/or property damage.

The engine, turbine, or other type of prime mover should be equipped with an overspeed (overtemperature, or overpressure, where applicable) shutdown device(s), that operates totally independently of the prime mover control device(s) to protect against runaway or damage to the engine, turbine, or other type of prime mover with possible personal injury or loss of life should the mechanical-hydraulic governor(s) or electric control(s), the actuator(s), fuel control(s), the driving mechanism(s), the linkage(s), or the controlled device(s) fail.

--------WARNING!------

CAUTION: To prevent damage to a control system that uses an alternator or battery-charging device, make sure the charging device is turned off before disconnecting the battery from the system.

Electronic controls contain static-sensitive parts. Observe the following precautions to prevent damage to these parts.

* Discharge body static before handling the control (with power to the control turned off, contact a grounded surface and maintain contact while handling the control).
* Avoid all plastic, vinyl, and Styrofoam (except antistatic versions) around printed circuit boards.
* Do not touch the components or conductors on a printed circuit board with your hands or with conductive devices.

IMPORTANT DEFINITIONS

WARNING - indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION - indicates a potentially hazardous situation which, if not avoided, could result in damage to equipment.

NOTE - provides other helpful information that does not fall under the warning or caution categories.

Revisions - Text changes are indicated by a black line alongside the text.

Caterpillar Information System:

RENR5912-07 G3616 Gas Engine Electrical System RENR5912-07 G3616 Gas Engine Electrical System
RENR5911-08 G3612 Gas Engine Electrical System RENR5911-08 G3612 Gas Engine Electrical System
Caterpillar G3408C and G3412C Industrial and Gen Set EIS Electrical System Caterpillar G3408C and G3412C Industrial and Gen Set EIS Electrical System
G3408C and G3412C Engine Electrical System 194-0911-03, 308-5686-02 G3408C and G3412C Engine Electrical System 194-0911-03, 308-5686-02
Caterpillar UPS 250 & UPS 300 Uninterruptible Power Supply Electrical System (Single Module System) Caterpillar UPS 250 & UPS 300 Uninterruptible Power Supply Electrical System (Single Module System)
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750, and UPS 900 Uninterruptible Power Supply Electrical System (Multi Module System) UPS 250, UPS 300, UPS 500, UPS 600, UPS 750, and UPS 900 Uninterruptible Power Supply Electrical System (Multi Module System)
Caterpillar PMG3516 Medium Voltage Power Module Switchgear Electrical System Caterpillar PMG3516 Medium Voltage Power Module Switchgear Electrical System
Caterpillar PMG3516 Low Voltage Power Module Switchgear Electrical System Caterpillar PMG3516 Low Voltage Power Module Switchgear Electrical System
Caterpillar CTG and CTGD Automatic Transfer Switch (ATS) Electrical System Caterpillar CTG and CTGD Automatic Transfer Switch (ATS) Electrical System
Caterpillar CTS and CTSD Automatic Transfer Switch (ATS) Electrical System Caterpillar CTS and CTSD Automatic Transfer Switch (ATS) Electrical System
C280-12 and C280-16 Marine Propulsion Engine Electrical System 273-4750-03 C280-12 and C280-16 Marine Propulsion Engine Electrical System 273-4750-03
C280-6 and C280-8 Marine Propulsion Engine Electrical System 273-4800-03 C280-6 and C280-8 Marine Propulsion Engine Electrical System 273-4800-03
PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER General Information
PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER Electrostatic Discharge Awareness
PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER Installation Procedure
PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER Description of Operation
PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER Troubleshooting
PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER Technical Specifications
PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER Service Options
PROACT II ELECTRIC POWERED ACTUATOR AND DRIVER ProAct II� Actuator/Driver Specifications
G3500 Engine Electrical System 114-8162-10 G3500 Engine Electrical System 114-8162-10
G3500 Generator Set with EMCPII+ Electrical System G3500 Generator Set with EMCPII+ Electrical System
G3306 Generator Set Electrical System (For Generator Set:JCA1-UP CNR1-UP and Engine: CTT1-UP) G3306 Generator Set Electrical System (For Generator Set:JCA1-UP CNR1-UP and Engine: CTT1-UP)
G3516B Generator Set Electrical System G3516B Generator Set Electrical System
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.