G342 ENGINE Caterpillar


Flywheel Runout

Usage:

Face Runout (axial eccentricity) of the Flywheel:


CHECKING FACE RUNOUT OF THE FLYWHEEL

1. Install the dial indicator as shown. Put a force on the flywheel toward the rear.

2. Set the dial indicator to read .000 in. (0.0 mm).

3. Turn the flywheel and read the indicator every 90°. Put a force on the flywheel to the rear before each reading.

4. The difference between the lower and higher measurements taken at all four points must not be more than .006 in. (0.15 mm), which is the maximum permissible face runout (axial eccentricity) of the flywheel.

Bore Runout (radial eccentricity) of the Flywheel:


CHECKING FLYWHEEL BORE


CHECKING FLYWHEEL CLUTCH PILOT BEARING BORE

1. Install the dial indicator (3) and make an adjustment of the universal attachment (4) so it makes contact as shown.

2. Set the dial indicator to read .000 in. (0.0 mm).

3. Turn the flywheel and read the indicator every 90°.

4. The difference between the lower and higher measurements taken at all four points must not be more than .006 in. (0.15 mm), which is the maximum permissible bore runout (radial eccentricity) of the flywheel.

5. Runout (eccentricity) of the bore for the pilot bearing for the flywheel clutch, must not exceed .005 in. (0.13 mm).

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.