D343 INDUSTRIAL & MARINE ENGINES Caterpillar


Crankshaft Rear Seal

Usage:

Remove Crankshaft Rear Seal

preparatory step:

a) remove flywheel

1. Using seal puller group (A) remove the crankshaft rear seal.

Install Crankshaft Rear Seal

1. Using tool (A), install the crankshaft rear seal as follows.

2. Install locator assembly (4) and three retaining bolts on the crankshaft.

3. Lubricate the lip of the seal and the crankshaft with clean SAE 30 engine oil. Coat the outside diameter of the seal with 8M8059 Loctite Sealant.

4. Install the seal over the seal pilot (5) and position them on the locator assembly. Install the seal with the lip toward the front of the engine.

5. Install the seal installer ring (3) with the smaller outside diameter toward the seal.

6. Install the pusher plate (2) and nut (1). Tighten the nut until the large diameter of the seal installer ring comes in contact with the seal cage.

7. Remove tool (A).

concluding step:

a) install flywheel

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.