Rain Gutter Panel Support May Be Installed Upside Down On Certain Generator Sets {7263, 7274}
- Generator Set
- XQ60 (S/N: CF91-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
485-3139 Support Panel (rain gutter) sometimes installed upside down. Channel should take any water ingression away from the front of the radiator, and not conflict with airflow. This issue is due to misunderstanding of part orientation and up fit in production line.
Solution
Show/hide table
 |
|
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility. |
Caterpillar is aware of this issue and working towards a permanent solution. As an interim action, documentation was updated and operators were given clear instruction on how to fit and to do 100% inspection on all these packages.
Caterpillar Information System:
Fogging May Appear Inside Monitor On Certain Mini Hydraulic Excavators {7490} Fogging May Appear Inside Monitor On Certain Mini Hydraulic Excavators {7490}
Procedure to Replace Commutator End (CE) Housing of Starter Motor On All Cat® Products {1408, 1450, 1453} Procedure to Replace Commutator End (CE) Housing of Starter Motor On All Cat® Products {1408, 1450, 1453}
Procedure to Replace Armature of Starter Motor On All Cat® Products {1408, 1450, 1453} Procedure to Replace Armature of Starter Motor On All Cat® Products {1408, 1450, 1453}
New Control and Panel Harness Assemblies are Now Used on Certain Cat® Engines {1408} New Control and Panel Harness Assemblies are Now Used on Certain Cat® Engines {1408}
Drive End Bearing Service For 50/75 Amp Brushless Alternators {1405} Drive End Bearing Service For 50/75 Amp Brushless Alternators {1405}
Updated Wiring Configuration is Now Used on Certain 3412 Generator Sets {1404} Updated Wiring Configuration is Now Used on Certain 3412 Generator Sets {1404}
Exhaust Rain Cap is Now Repositioned on Certain C7.1 Generator Set Engines {1072} Exhaust Rain Cap is Now Repositioned on Certain C7.1 Generator Set Engines {1072}
26SI Reman Charging Alternator Group Has Been Discontinued {1405} 26SI Reman Charging Alternator Group Has Been Discontinued {1405}
Water Couplings Can Be Damaged from Over Torquing on Certain C175 Engines {1380} Water Couplings Can Be Damaged from Over Torquing on Certain C175 Engines {1380}
Preservation Procedure for Intake System Is Now Used on Certain Cat® Engines {1052, 1053, 1201, 1216} Preservation Procedure for Intake System Is Now Used on Certain Cat® Engines {1052, 1053, 1201, 1216}
A False 1684-12 Code May Trip on Certain Tier 4 C175 Off-Highway Truck Engines {125H} A False 1684-12 Code May Trip on Certain Tier 4 C175 Off-Highway Truck Engines {125H}
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting Sensor (Data Link Type) - Test
320 GC, 320 and 323 Excavator Machine Systems Specifications Swing Motor
New Coolant Lines for Pump Electronic Tank Unit (PETU) are Now Used on Certain Off-Highway Trucks {108U, 1380} New Coolant Lines for Pump Electronic Tank Unit (PETU) are Now Used on Certain Off-Highway Trucks {108U, 1380}
A New Crankcase Breather Assembly Clamp is Now Used for Certain C175 Commercial Engines {1317} A New Crankcase Breather Assembly Clamp is Now Used for Certain C175 Commercial Engines {1317}
The Dosing Cabinet and Clean Emissions Module for the Retrofit Aftertreatment is Discontinued {108X} The Dosing Cabinet and Clean Emissions Module for the Retrofit Aftertreatment is Discontinued {108X}
Commissioning Procedure for 794 AC, 796 AC, and 798 AC Off-Highway Trucks is Updated {1000, 7000, 7961} Commissioning Procedure for 794 AC, 796 AC, and 798 AC Off-Highway Trucks is Updated {1000, 7000, 7961}
The Wiper Motor May Fail on Certain Next Generation Hydraulic Excavators {7305} The Wiper Motor May Fail on Certain Next Generation Hydraulic Excavators {7305}
140 Motor Grader Machine Systems Steering Accumulator - Remove and Install
New Improved Fuel Level Sensor Assembly is Now Used on Certain Generator Sets and Power Modules {1439, 7481} New Improved Fuel Level Sensor Assembly is Now Used on Certain Generator Sets and Power Modules {1439, 7481}
Box Handling and Storage of Cat® PVT 110 and PVT 110 ARC Photo Voltaic Module {1471} Box Handling and Storage of Cat® PVT 110 and PVT 110 ARC Photo Voltaic Module {1471}
Adding the Jacket Water Coolant Pressure Monitor to the Digital Control Unit {191W, 7451} Adding the Jacket Water Coolant Pressure Monitor to the Digital Control Unit {191W, 7451}
Troubleshooting Procedure is Now Available for Water In Liquid Level Sensor on Certain Excavators {7422} Troubleshooting Procedure is Now Available for Water In Liquid Level Sensor on Certain Excavators {7422}
301.5, 301.6, 301.7 CR, 301.8, and 302 CR Mini Hydraulic Excavator Machine System General Calibration Information - Cat ET