Assembly Procedure
Show/hide table
Table 1
Required Tools |
Tool |
Part Number |
Part Description |
Qty |
A |
1P-0510 |
Driver Group |
1 |
Note: Cleanliness is an important factor. Before the assembly procedure, the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Note: Check all the O-ring seals and the components for wear or damage. Replace the components, if necessary. Lubricate the O-ring seals lightly with the lubricant that is being sealed.
Show/hide table
|
|
|
Illustration 1 | g06166710 |
If two terminal bushings were removed, use a suitable press and Tooling (B) (not shown) to install two terminal bushings into the body assembly.
|
Note: The seams of two terminal bushings should be indexed closest to the center of the body assembly.
Note: The tops of bearings should protrude between 5.59 mm (0.22 inch) and 5.84 mm (0.23 inch).
Show/hide table
|
|
|
Illustration 2 | g06166712 |
Coat the insideof the body assembly with clean hydraulic oil.
|
Note: Install bottom isolation plate with the rounded edge toward the bottom of the body assembly.
Show/hide table
|
|
|
Illustration 3 | g06166714 |
Note: Install pressure plate with the bronze surface toward the drive shaft and the idler gear.
Show/hide table
|
|
|
Illustration 4 | g06166716 |
Show/hide table
|
|
|
Illustration 5 | g06166720 |
Note: Install pressure plate with the bronze surface toward the drive shaft and the idler gear.
Show/hide table
|
|
|
Illustration 6 | g06166724 |
Show/hide table
|
|
|
Illustration 7 | g06166728 |
If two terminal bushings were removed, use a suitable press and Tooling (B) (not shown) to install two terminal bushings into the body assembly.
|
Note: The seams of two terminal bushings should be indexed closest to the center of the body assembly.
Note: The tops of bearings should protrude between 5.59 mm (0.22 inch) and 5.84 mm (0.23 inch).
Show/hide table
|
|
|
Illustration 8 | g06166733 |
Show/hide table
|
|
|
Illustration 9 | g06166804 |
Reference photo of orientation of the seals during installation.
|
Show/hide table
|
|
|
Illustration 10 | g06166739 |
End By:
- Install the gear pump for the steering oil cooler.