Illustration 1 | g06058026 |
Illustration 2 | g06058029 |
Parking Brake Manual Release (1)
This message is on top of the machine, close to the parking brake manual release valve. Refer to Operation and Maintenance Manual, "Towing Information", and “Parking Brake Manual Release” for more information.
Illustration 3 | g03325967 |
This message is located near both auger conveyor lubrication points, the drag conveyor lubrication points, and the front idler lubrication points. Refer to Operation and Maintenance Manual, "Drag Conveyors - Lubricate" for more information.
Illustration 4 | g02387467 |
Diesel Fuel Recommendations (3)
This message is located next to the fuel cap.
Illustration 5 | g02157153 |
NACD Film |
Illustration 6 | g02052934 |
EAME Film |
Use Ultralow Sulfur Diesel (ULSD) fuel.
The United States (U.S.) Environmental Protection Agency (EPA) defines Ultra-Low Sulfur Diesel (ULSD - S15) as a U.S. diesel fuel with a sulfur content not to exceed 15 parts per million (ppm(mg/kg)) or 0.0015 percent by weight. Engines certified to nonroad Tier 4 standards (Stage IV in Europe) and are equipped with exhaust aftertreatment systems are designed to run on ULSD only. Use of LSD or fuels higher than 15 ppm (mg/kg) sulfur in these engines will reduce engine efficiency and engine durability and will damage emissions control systems and/or shorten the service interval. Failures that result form the use of fuels are not Cat factory defects. Therefore the cost of repairs would not be covered by a Cat warranty.
In Europe, ultra low sulfur diesel fuel will have a maximum of 0.0010 percent (10 ppm(mg/kg)) sulfur and is typically referred to as “sulfur-free”. This sulfur level is defined in European Standard "EN 590:2004".
Refer to Special Publication, SEBU6250, "Caterpillar Machine Fluids Recommendations" for more information about diesel fuels and sulfur.
Refer to Operation and Maintenance Manual, "Capacities (Refill)".
This message is located near both connections for the auger sensor on the rear of the machine.
Illustration 7 | g03841202 |
This message is located near both connections for the conveyor sensor on the rear of the machine.
Illustration 8 | g03841203 |
This message is on the operators platform near the exhaust stack.
Illustration 9 | g01418953 |
The Product Link System is a satellite communication device that transmits information regarding the machine back to Caterpillar and Caterpillar dealers and customers. All logged events and diagnostic codes that are available to the Caterpillar Electronic Technician (ET) on the CAN bus, can be sent to the satellite. Information can also be sent to the Product Link System. The information is used to improve Caterpillar products and Caterpillar services.
Refer to Operation and Maintenance Manual, "Product Link" for more information.
Manuals Storage Compartment (7)
This message is on the left side of the right seat, on the manuals storage compartment.
Illustration 10 | g03326023 |