New Scraper Mounting for Certain Asphalt Compactors {6607}
- Engine
- C7 (S/N: JKL1-UP)
- Vibratory Asphalt Compactor
- CB44B (S/N: TWC1-UP; NSL1-UP)
- CB54B (S/N: LXD1-UP; RJN1-UP; S4P1-UP)
- CD44B (S/N: 3981-UP; JXE1-UP)
- CD54B (S/N: GRT1-UP; J9T1-UP)
- CB54B (S/N: LXD1-UP; RJN1-UP; S4P1-UP)
Description Of Change: New bracket and hardware for scraper mounting are now available. The new support plate is thicker to provide extended reliability. Refer to Special Instruction , SEHS0529.
Adaptable To: These changes apply to the following models.
Show/hide table
| Adaptable | |
|---|---|
| Sales Model | Serial Number Range |
| CB44B | JXL 1 - 170 |
| NSL 1 - 218 | |
| TWC 1 - 151 | |
| CB54B | LXD 1 - 308 |
| RJN 1 - 212 | |
| S4P 1 - 232 | |
| CD44B | 398 1 - 104 |
| JXE 1 - 129 | |
| CD54B | GRT 1 - 139 |
| J9T 1 - 104 | |
Show/hide table
| Effected | |
|---|---|
| Sales Model | Serial Number Range |
| CB44B | JXL 171 - Up |
| NSL 219 - Up | |
| TWC 152 - Up | |
| CB54B | LXD 309 - Up |
| RJN 213 - Up | |
| S4P 233 - Up | |
| CD44B | 398 105 - Up |
| JXE 130 - Up | |
| CD54B | GRT 140 - Up |
| J9T 105 - Up | |
Required Parts
Show/hide table
| Parts List | |||
|---|---|---|---|
| Item | Qty | Part Number | Part Name |
| 1 | 4 | Nut | |
| 2 | 8 | Nut | |
| 3 | 4 | Bracket As | |
| 4 | 4 | Rod End | |
| 5 | 4 | Bolt | |
| 6 | 4 | Bolt | |
| 7 | 16 | Hard Washer | |
| 8 | 2 | Mat Support | |
Caterpillar Information System:
C12.9 Marine Engines Sensors and Electrical Components
C18 Generator Set Engines Fuel Priming Pump - Remove and Install
C12.9 Marine Engines Starting Aid (Air Inlet Heater) - Inspect/Clean/Replace
A New Caterpillar Regeneration System (CRS) Pump Is Now Used For Certain Tier 4 Final Engines {1258} A New Caterpillar Regeneration System (CRS) Pump Is Now Used For Certain Tier 4 Final Engines {1258}
New O-Ring Seal Kit Is Available for Use on Raptor Fuel Valve Sensor Module {1741, 5137} New O-Ring Seal Kit Is Available for Use on Raptor Fuel Valve Sensor Module {1741, 5137}
New 441-4414 Exhaust Manifold Is Available for Use on Certain G3520C Landfill Engines {1059} New 441-4414 Exhaust Manifold Is Available for Use on Certain G3520C Landfill Engines {1059}
Cat® Command For Hauling E1189
C11 and C13 Engines for Caterpillar Built Machines Gear Group (Rear) - Remove and Install
C11 and C13 Petroleum Engines Gear Group (Rear) - Remove and Install
C1.7 and C2.2 Industrial Engine Relay - Test - Start Relay
C12.9 Marine Engines Engine Speed/Timing Sensor - Clean/Inspect
Installing Inducement Override Switch and Wiring for 3516C & C175-16 Tier 4I Engines That Uses an EMCP 4.2 Panel {1408, 7405, 7451, 7553, 7556} Installing Inducement Override Switch and Wiring for 3516C & C175-16 Tier 4I Engines That Uses an EMCP 4.2 Panel {1408, 7405, 7451, 7553, 7556}
G3516 TA Engine Electronic Control System Operation
G3516 TA Engine Engine Governing
New Engine Diagnostic Codes Software is Now Used on G3500E Gas Engines {1920} New Engine Diagnostic Codes Software is Now Used on G3500E Gas Engines {1920}
New Control Harness Assemblies Are Now Used on Certain G3306B Engines {1408, 1900} New Control Harness Assemblies Are Now Used on Certain G3306B Engines {1408, 1900}
Check for the Correct Bolt Torque for the Air Shutoff Butterfly Plate on Certain 3500 Engines {1078} Check for the Correct Bolt Torque for the Air Shutoff Butterfly Plate on Certain 3500 Engines {1078}
795F AC and 795F AC XQ Off-Highway Trucks Hood Tilt
Caterpillar Machine Fluids Recommendations Warranty Information
Introduction to Visualization Service Procedure (VSP) {0374, 1000, 7000} Introduction to Visualization Service Procedure (VSP) {0374, 1000, 7000}
A New Visualization Service Procedure (VSP) is Now Used for Certain Publications {0374, 1000, 7000} A New Visualization Service Procedure (VSP) is Now Used for Certain Publications {0374, 1000, 7000}
A New Visualization Service Procedure (VSP) is Now Used for Certain Publications {0374, 1000, 7000} A New Visualization Service Procedure (VSP) is Now Used for Certain Publications {0374, 1000, 7000}
G3516 TA Engine Engine Sensors
G3508J, G3516J, and G3520J Engines Fuel Control Valve - Remove and Install