C13 and C15 Engines for Combat and Tactical Vehicles Caterpillar

Customer Specified Parameters Table

Usage:

C13 EMS

Show/hide table

Table 1
Table for Customer Specified Parameters
Parameter	Available Range or Options	Default
Selected Engine Rating
Rating Number	Dependent on engine power
Multitorque Ratio	Unavailable (Standard Ratings) MT-A MT-B MT-C	Unavailable (Standard Ratings) MT-A (Multitorque Ratings)
Selected Engine Rating
Vehicle ID	17 Digits Available characters are dependent on the service tools.	all zeroes
Security Access Parameters
ECM Wireless Communication Enable	Yes No	No
Vehicle Speed Parameters
Vehicle Speed Calibration	2485 to 93226 PPKM (4000 to 150000 PPM)	Not Programmed
Vehicle Speed Cal (J1939 - Trans)	0 to 43000 revolutions per km (0 to 65000 revolutions per mile)	Not Programmed
Vehicle Speed Cal (J1939 - ABS)	0 to 6.550	Not Programmed
Vehicle Speed Limit	48 to 204 km/h (30 to 127 mph)	204 km/h (127 mph)
VSL Protection	1000 to TEL rpm	TEL rpm
Tachometer Calibration	12.0 to 500.0 pulses per revolution	113.0 pulses per revolution
Soft Vehicle Speed Limit	Yes No	No
Two Speed Axle - Low Speed Range Axle Ratio	1.00 to 19.99	1.00
Nominal Axle Ratio - High Speed Range Axle Ratio	1.0 to 9.99	1.00
Cruise Control Parameters
Low Cruise Control Speed Set Limit	24 to 204 km/h (15 to 127 mph)	204 km/h (127 mph)
High Cruise Control Speed Set Limit	48 to 204 km/h (30 to 127 mph)	204 km/h (127 mph)
Cruise/Idle/PTO Switch Configuration	Set/Accel-Res/Decel Set/Decel-Res/Accel	Set/Accel-Res/Decel
Soft Cruise Control	Yes No	Yes
Adaptive Cruise Control Enable	Disabled Enabled	Disabled
Idle Parameters
Idle Vehicle Speed Limit	2 to 24 km/h (1 to 15 mph)	2 km/h (1 mph)
Idle RPM Limit	Low Idle to 2120 rpm	2120 rpm
Idle/PTO RPM Ramp Rate	5 to 1000 rpm/sec	50 rpm/sec
Idle/PTO Bump RPM	5 to 500 rpm	20 rpm
Dedicated PTO Parameters
PTO Configuration	Cab Switches Off Remote Switches Remote Throttle	Off
PTO Top Engine Limit	Low Idle to 2120 rpm	2120 rpm
PTO Engine RPM Set Speed (0 = Off)	Low Idle to PTO TEL rpm	0
PTO Engine RPM Set Speed A	Low Idle to PTO TEL rpm	0
PTO Engine RPM Set Speed B	Low Idle to PTO TEL rpm	0
PTO to Set Speed	Yes No	No
Maximum PTO Enable Speed	Low Idle to PTO TEL rpm	PTO TEL rpm
PTO Cab Controls RPM Limit	Low Idle TEL PTO TEL	TEL
PTO Kickout Vehicle Speed Limit	2 to 204 km/h (1 to 127 mph)	2 km/h (1 mph)
Max PTO Vehicle Speed	24 to 204 km/h (15 to 127 mph)	204 km/h (127 mph)
Torque Limit	270 N·m (200 lb ft) to Rated Torque	3400 N·m (2500 lb ft)
PTO Shutdown Time (0 = Off)	3 to 1440 minutes	0
PTO Shutdown Timer Maximum RPM	600 to PTO TEL rpm	PTO TEL rpm
PTO Activates Cooling Fan	Normal Continuous	Normal
Engine/Gear Parameters
Lower Gears Engine RPM Limit	1100 to TEL rpm	TEL rpm
Lower Gears Turn Off Speed	5 to 48 km/h (3 to 30 mph)	5 km/h (3 mph)
Intermediate Gears Engine RPM Limit	1100 to TEL rpm	TEL rpm
Intermediate Gears Turn Off Speed	8 to 80 km/h (5 to 50 mph)	8 km/h (5 mph)
Gear Down Protection RPM Limit	1300 to TEL rpm	TEL rpm
Gear Down Protection Turn On Speed	48 to 204 km/h (30 to 127 mph)	204 km/h (127 mph)
Low Idle Engine RPM	600 to 750 rpm	600 rpm
Transmission Style	Automatic Option 1 Automatic Option 2 Automatic Option 3 Automatic Option 4 Eaton Top 2 Manual Option 1	Manual Option 1
Eaton Top 2 Override with Cruise Switch	Yes No	No
Top Gear Ratio	0.000 to 3.750	0.000
Top Gear Minus One Ratio	0.000 to 3.750	0.000
Top Gear Minus Two Ratio	0.000 to 3.750	0.000
Governor Type	Full Range Min/Max Min/Max with Speed Control	Full Range
Default Torque Limit Master Source Address (C13 RLG only)	0 to 253	0 (disabled)
Timer Parameters
Idle Shutdown Time (0 = Off)	1 to 1440 minutes	0 minutes
Idle Shutdown Timer Maximum RPM	Low Idle to 2120 rpm	2120 rpm
Allow Idle Shutdown Override	Yes No J1587 Outside Temp Based Outside Temperature Based	Yes
Minimum Idle Shutdown Outside Temp	−40° to 49°C (−40° to 120°F)	49 °C (120 °F)
Maximum Idle Shutdown Outside Temp	−40° to 49°C (−40° to 120°F)	49 °C (120 °F)
A/C Switch Fan On-Time (0 = Off)	1 to 600 seconds	0 seconds
Smart Idle Parameters
Battery Monitor and Engine Control Voltage	0 to 25.5 volts	0.0 volts
Engine Monitoring Parameters
Engine Monitoring Mode	Warning Derate Shutdown	Warning
Engine Monitoring Lamps	Option 1 Warning Lamp	Warning Lamp
Coolant Level Sensor	2-wire Float Sensor 4-pin No	No
Engine Coolant Temperature Derate Enable Status This parameter is not supported in DEC 2003 and newer software.	Enabled Disabled	Disabled
Maintenance Parameters
Maintenance Indicator Mode	Automatic Distance Automatic Hours Manual Distance Manual Hours Off	Off
PM 1 Interval (Manual Maintenance Indicator Mode)	8050 to 56325 km (5000 to 35000 miles) 100 to 750 hours	24140 km (15000 miles) 250 hours
Engine Oil Capacity	19 to 57 L (20 to 60 qt)	C11, C13: 34 L (36 qt) C15: 38 L (40 qt)
Trip Parameters
Fuel Correction Factor	−63.5 to 63.5 %	0 %
Dash-Change Fuel Correction Factor	Yes No	No
Dash-PM 1 Reset	Yes No	No
Dash-Fleet Trip Reset	Yes No	No
Dash-State Selection	Yes No	Yes
Theft Deterrent System Control	Yes No Auto-Enable	No
Theft Deterrent Password	Four Characters	0000
Quick Stop Rate	5 to 24 km/h per sec (3 to 15 mph per sec)	0 km/h per sec (0 mph per sec)
Vehicle Overspeed Threshold	48 to 204 km/h (30 to 127 mph)	204 km/h (127 mph)
Vehicle Activity Report Parameters
Minimum Idle Time (0 = Off)	0 to 1440 minutes	0 minutes
Driver Reward
Driver Reward Enable	Enabled Disabled	Enabled
Input Selections
Fan Override Switch	None J1/P1:46 J1/P1:47 J1/P1:6 J1/P1:7 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	None
Transmission Neutral Switch	None J1939 J1/P1:62	None
Ignore Brake/Clutch Switch	None J1/P1:47	None
Torque Limit Switch	None J1/P1:7	None
Diagnostic Enable	None J1/P1:46 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	None
PTO On/Off Switch	J1/P1:56 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	J1/P1:56
Remote PTO Set Switch	None J1/P1:58 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	J1/P1:58
Remote PTO Resume Switch	None J1/P1:60 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	J1/P1:60
PTO Engine RPM Set Speed Input A	None J1/P1:6 J1/P1:46 J1/P1:58 J1/P1:60 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	None
PTO Engine RPM Set Speed Input B	None J1/P1:6 J1/P1:46 J1/P1:58 J1/P1:60	None
Starting Aid On/Off Switch	None J1/P1:6 J1/P1:7 J1/P1:46 J1/P1:47	None
Two-Speed Axle Switch	None J1/P1:6 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	None
Cruise Control On/Off Switch	J1/P1:59 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	J1/P1:59
Cruise Control Set/Resume/Accel/Decel Switch	J1/P1:35 & 44 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	J1/P1:35 & 44
Cruise Control Pause Switch	None J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	None
Clutch Pedal Position Switch	J1/P1:22 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	J1/P1:22
Service Brake Pedal Position Switch #1	J1/P1:45 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster	J1/P1:45
Accelerator Pedal Position	J1/P1:66	J1/P1:66
Vehicle Speed Input	J1/P1:32 & 33 J1939 − ABS J1939 − Trans	J1/P1:32 & 33
Output Selections
Engine Running Output	None J1/P1:10 J1/P1:12 J1/P1:13	None
Engine Shutdown Output	None J1/P1:10 J1/P1:12 J1/P1:13	None
Auxiliary Brake	None J1/P1:12	None
Starting Aid Output	None J1/P1:10 J1/P1:12 J1/P1:13	None
Fan Control Type	None On/Off PWM On/Off DC Three-Speed Fan PWM Three-Speed Fan DC Variable Speed Fan Option S	None
PTO Active Output	None J1/P1:19	None
Customer Passwords
Customer Password #1	8 Digits Available characters are dependent on the service tools.	Not Programmed
Customer Password #2		Not Programmed
Data Link Parameters
Power Train Data Link	None J1939	J1939