3516C Marine Engines Caterpillar


Fuel Injector

Usage:

3516C TKG


Illustration 1g03708722

Table 1
Specification for 374-7121 Fuel Injection Pump Gp 
Item  Qty  Part  Specification Description 
Before assembly, lubricate the injector bore with 1P-0808 Multipurpose Grease. 
7F-8698 Bolt  Torque to 65 ± 7 N·m (48 ± 5 lb ft)
Timing dimension is 64.34 ± 0.20 mm (2.533 ± 0.008 inch)

Caterpillar Information System:

462-1133 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 462-1133 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
C27 and C32 Generator Set Engines Fan Drive
3306B-XQ200 Rental Generator Set Engine Refill Capacities
C13 Industrial Engine Diagnostic Capabilities
C4.4 Engines for Caterpillar Built Machines Aftertreatment SCR System Dosing - Test
2014/10/03 New Wiring Harnesses Are Used on Certain C175 Marine and Petroleum Engines {1408}
C13 Industrial Engine Diesel Particulate Filter Regeneration
2014/08/07 Ash Service Reset Clarification for Certain Truck Engines {108F}
C13 Industrial Engine General Information
462-1062 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 462-1062 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
Scrap Barrel Analysis {0374, 0599, 0700, 0701, 0738, 1000, 7000} Scrap Barrel Analysis {0374, 0599, 0700, 0701, 0738, 1000, 7000}
460-9818 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 460-9818 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
3516C Marine Engines Turbocharger Oil Lines
460-8972 Major Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 460-8972 Major Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
PM820, PM822, and PM825 Cold Planer Track Shoe Bolts - Tighten
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Speed Control - Test
3516C Marine Engines Exhaust Elbow
3512C Engine Air Inlet Manifold - Remove and Install
C175-16 Locomotive Engine Speed/Timing - Test
3516B Generator Set Engines with Dynamic Gas Blending Inlet Air Is Restricted
PM820, PM822, and PM825 Cold Planer Tracks - Inspect
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Transmission Oil Temperature Is High
PM820, PM822, and PM825 Cold Planer Upper Conveyor Deflectors (Second Stage) - Inspect/Replace
PM820, PM822, and PM825 Cold Planer Upper Conveyor Support Cables - Check
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.